Age | Commit message (Collapse) | Author |
|
container: T5407: increase priority before protocol static
|
|
Ability to set locate time format 12|24-hour
set system option time-format 12-hour|24-hour
$ date
Tue Aug 1 12:33:45 PM EEST 2023
$ date
Tue 1 Aug 12:34:09 EEST 2023
|
|
|
|
Change code for new syntax
|
|
balance within a single rule.
|
|
When no-release is specified, dhcp6c client will not release allocated address or prefix on client exit.
vyos.ifconfig: dhcpv6: T5387: re-use options_file for no release flag [WIP]
* Todo: render Jinja2 template and fill it
vyos.ifconfig: dhcpv6: T5387: finish options_file and no release flag in cli
vyos.ifconfig: dhcpv6: T5387: fix missing/wrong end tag
vyos.ifconfig: dhcpv6: T5387: fix options, no var for -n
dhcpv6-client: T5387: fix missing / from filepaths
|
|
T5368: service ids ddos-protection add support sflow mode
|
|
inetfaces
Keep a common CLI structure by re-using the already established offload
node from ethernet.
|
|
|
|
T5154: NTP: allow maximum of one ipv4 and one ipv6 address on paramet…
|
|
<listen-address>. Also allow only one single value <interface>.
|
|
T4889: NAT Redirect: adddestination nat redirection (to local host) feature.
|
|
T4974:add/fixed enable ovpn-dco by default
|
|
|
|
|
|
sFlow mode requires fewer resources then mode "mirror"
Integrate it into configuration mode
set service ids ddos-protection mode 'sflow'
set service ids ddos-protection sflow listen-address '127.0.0.1'
set service ids ddos-protection sflow port '6343'
|
|
New CLI commands:
* set protocols ospf graceful-restart grace-period 300
* set protocols ospf graceful-restart helper planned-only
* set protocols ospf graceful-restart helper no-strict-lsa-checking
* set protocols ospf graceful-restart helper supported-grace-time 400
* set protocols ospf graceful-restart helper enable router-id 192.0.2.1
* set protocols ospf graceful-restart helper enable router-id 192.0.2.2
* set protocols ospfv3 graceful-restart grace-period 300
* set protocols ospfv3 graceful-restart helper planned-only
* set protocols ospfv3 graceful-restart helper lsa-check-disable
* set protocols ospfv3 graceful-restart helper supported-grace-time 400
* set protocols ospfv3 graceful-restart helper enable router-id 192.0.2.1
* set protocols ospfv3 graceful-restart helper enable router-id 192.0.2.2
|
|
|
|
validor for dhcpv6-relay which was missing.
|
|
|
|
|
|
bgp: T5338: Added 'protocols bgp interface <int> mpls forwarding' feature
|
|
Added 'protocols bgp interface <int> mpls forwarding' feature.
It is possible to permit BGP install VPN prefixes without transport labels.
This configuration will install VPN prefixes originated from an e-bgp session,
and with the next-hop directly connected.
|
|
Migrate:
high-availability virtual-server 203.0.113.1
to: high-availability virtual-server <name> address 203.0.113.1
|
|
|
|
bgp: T5343: add ipv4-vpn and ipv6-vpn config options to peer-group
|
|
T775: Add service config-sync between 2 routers
|
|
|
|
|
|
|
|
* set protocols ospf aggregation timer <seconds>
* set protocols ospf summary-address x.x.x.x/x [tag 1-4294967295]
* set protocols ospf summary-address x.x.x.x/x no-advertise
|
|
|
|
After an interface is added/removed from VPP, it will be reinitialized, which
allows reconfiguring IP addresses on it.
Also modified VPP load priority to start before interfaces, and avoid
reconfiguration during boot.
|
|
|
|
Service config-sync allows synchronizing a section of
the configuration.
As PoC allow only nat, nat66 and firewall sections
Rertreive the configuration for a section from self node and
send this configuration to the section of the 'secondary' node.
This feature adds a symlink from helper 'vyos_config_sync.py'
to '/config/scripts/commit/post-hooks.d' and config that is
located in '/run/config_sync_conf.conf'
It will synchronyze the config only if the setcion
was changed.
set service config-sync secondary address 192.0.2.11
set service config-sync secondary key xxx
set service config-sync section nat
set service config-sync section nat66
set service config-sync section firewall
set service config-sync mode load
|
|
T1797: Add initial vpp configuration
|
|
The previous implementation did not iterate over the communit list, so only
one match criteria was supported.
set policy route-map FOO rule 10 action 'permit'
set policy route-map FOO rule 10 set extcommunity rt '1111:2222222'
worked but on the other hand this failed:
set policy route-map FOO rule 20 action 'permit'
set policy route-map FOO rule 20 set extcommunity rt '6500:24 6500:23 192.168.0.1:111 192.168.0.1:222'
|
|
T5304: Container add volume bind propagation option
|
|
set container name c1 volume myvlm propagation rshared
|
|
Add initial configuration mode for VPP (PoC)
set vpp cpu corelist-workers '2'
set vpp cpu main-core '1'
set vpp interface eth1 num-rx-desc '256'
set vpp interface eth1 num-rx-queues '512'
set vpp interface eth1 num-tx-desc '256'
set vpp interface eth1 num-tx-queues '512'
set vpp interface eth1 pci '0000:02:00.0'
set vpp interface eth1 rx-mode 'polling'
set vpp interface eth2 pci '0000:08:00.0'
Limitation:
- 'set vpp interface ethX pci auto' works only per first
commit, then interface detached from default stack and creates
tun interface 'ethX' to communicate with default stack. In this
case we can't get PCI address via ethtool for 'tun' interfaces.
But we can set pci address manualy.
- Interface sync between default stack and VPP-DPDK stack
After vpp change it doesn't trigger iproute2 for changes
(should be written later)
I.e. if we change something in vpp per each commit it restarts
vpp.service it gets empty interface config as we don't configure vpp
directly and it should be configured via iproute2
But then if we do any change on interface (for example description)
it gets IP address, MTU, state, etc.
|
|
|
|
set high-availability vrrp group <name> version 2|3
|
|
|
|
|
|
|
|
T5283: ipoe-server: add more flexibility in subnet parameter.
|
|
... this is a step towards a new and better implementation that will utilize
VPP.
|
|
|
|
|
|
This should make the help messages more consistent for DNS related
CLI subtree.
|