summaryrefslogtreecommitdiff
path: root/python/vyos/ifconfig
AgeCommit message (Collapse)Author
2022-08-29ethernet: T4653: bugfix copy-paste when processing NIC offloadingChristian Poessinger
Commit 31169fa8a763e ("vyos.ifconfig: T3619: only set offloading options if supported by NIC") added the new implementation which handles NIC offloading. Unfortunately every single implementation was copied from "gro" which resulted in a change to gro for each offloading option - thus options like lro, sg, tso had no effect at all. It all comes down to copy/paste errors ... one way or another.
2022-08-27pppoe: T4648: do not install IPv6 default route from RA is no-default-route ↵Christian Poessinger
is set Adds a sysctl parameter to ignore the default router obtained from router advertisements when pppoe no-default-route is set.
2022-08-25ifconfig: T2223: add vlan switch for Section.interfaces()Christian Poessinger
Sometimes we are only interested in the parent interfaces without any VLAN subinterfaces. Extend the API with a vlan argument that defaults to True to keep the current behavior in place.
2022-08-22bridge: T4632: vlan aware bridge lacks CPU forwardingChristian Poessinger
The VLAN aware bridge was forwarding traffic between member ports, but traffic destined torwards the CPU was dropped. This resulted in a gateway not reachable or DHCP leases that could not be handed out. Tested via: VyOS set interfaces bridge br0 enable-vlan set interfaces bridge br0 member interface eth1 allowed-vlan '10' set interfaces bridge br0 member interface eth1 allowed-vlan '20' set interfaces bridge br0 member interface eth1 allowed-vlan '30' set interfaces bridge br0 member interface eth1 allowed-vlan '40' set interfaces bridge br0 member interface eth1 native-vlan '40' set interfaces bridge br0 member interface eth2 allowed-vlan '30' set interfaces bridge br0 member interface eth2 allowed-vlan '20' set interfaces bridge br0 member interface eth2 allowed-vlan '10' set interfaces bridge br0 member interface eth2 allowed-vlan '40' set interfaces bridge br0 vif 10 address '10.0.10.1/24' set interfaces bridge br0 vif 20 address '10.0.20.1/24' set interfaces bridge br0 vif 30 address '10.0.30.1/24' set interfaces bridge br0 vif 40 address '10.0.40.1/24' Arista vEOS vlan 10,20,30,40 interface Ethernet1 switchport trunk allowed vlan 10,20,30,40 interface Vlan10 ip address 10.0.10.2/24 interface Vlan20 ip address 10.0.20.2/24 interface Vlan30 ip address 10.0.30.2/24 interface Vlan40 ip address 10.0.40.2/24 interface Ethernet1 switchport trunk allowed vlan 10,20,30,40 switchport mode trunk spanning-tree portfast Cisco vIOS interface GigabitEthernet0/0 ip address 10.0.40.3 255.255.255.0 duplex auto speed auto media-type rj45 ! interface GigabitEthernet0/0.10 encapsulation dot1Q 10 ip address 10.0.10.3 255.255.255.0 ! interface GigabitEthernet0/0.20 encapsulation dot1Q 20 ip address 10.0.20.3 255.255.255.0 ! interface GigabitEthernet0/0.30 encapsulation dot1Q 30 ip address 10.0.30.3 255.255.255.0 !
2022-08-01mtu: T4572: Add DHCP-option MTU to get values from DHCP-serverViacheslav Hletenko
Ability to get MTU from DHCP-server and don't touch it per any interface change if interface 'dhcp-options mtu' is configured
2022-07-30bridge: T4579: cleanup interface dict (remove empty keys)Christian Poessinger
2022-07-30bridge: T4579: remove duplicate code path already handled by base classChristian Poessinger
Interface() base class already takes care about VLAN creation/removal of newly added or no longer required interfaces. No need to code this logic again.
2022-07-15bond: T4525: fix adding member interface to bond after removing VRFChristian Poessinger
When removing a VRF from an ethernet interface and adding the interface to a bond in the same commit led to an OSError: [Errno 16] Device or resource busy!
2022-07-14interface: T4056: Fix unexpected delete tc qdiscDaniilHarun
2022-07-10bond: T4522: add ability to specify mii monitor interval via CLIChristian Poessinger
Linux Kernel supports to specify the MII link monitoring frequency in milliseconds. This determines how often the link state of each slave is inspected for link failures. A value of zero disables MII link monitoring. A value of 100 is a good starting point. The default value is 100. set interfaces bonding bond0 mii-mon-interval <n>
2022-07-10bond: T1557: re-add miimon configuration - lost in translationChristian Poessinger
2022-07-10bond: T4521: ARP monitor interval is not configured despite set via CLIChristian Poessinger
The code path for changing the interval is never executed.
2022-07-09ip: T4517: add option to enable directed broadcast forwardingYuxiang Zhu
Directed broadcast is described in rfc1812#section-5.3.5.2 and rfc2644. By default Linux kernel doesn't forward directed broadcast packets unless both of `/proc/sys/net/ipv4/conf/all/bc_forwarding` and `/proc/sys/net/ipv4/conf/$iface/bc_forwarding` are set to 1.
2022-07-01vti: T2455: add link-local IPv6 address supportChristian Poessinger
Interface should receive an auto generated link-local IPv6 address as we do with all VyOS interfaces by default.
2022-06-29bridge: add option to enable/disable IGMP/MLD snoopingYuxiang Zhu
This PR adds an config option to enable/disable IGMP/MLD snooping. ``` set interfaces bridge brN igmp snooping ```
2022-06-16vyos.ifconfig: T4384: fix file permission (664) on interface.pyChristian Poessinger
2022-04-21pppoe: T4384: replace default-route CLI option with common CLI nodes already ↵Christian Poessinger
present for DHCP VyOS 1.4 still leverages PPPd internals on the CLI. pppd supports three options for a default route, none, auto, force. * none: No default route is installed on interface up * auto: Default route is only installed if there is yet no default route * force: overwrite any default route There are several drawbacks in this design for VyOS and the users. If auto is specified, this only counted for static default routes - but what about dynamic ones? Same for force, only a static default route got replaced but dynamic ones did not got taken into account. The CLI is changed and we now re-use already existing nodes from the DHCP interface configuration: * no-default-route: On link up no default route is installed, same as the previous default-route none * default-route-distance: We can now specify the distance of this route for the routing table on the system. This defaults to 210 as we have for DHCP interfaces. All this will be migrated using a CLI migration script.
2022-04-21vyos.ifconfig: T4384: get_interface_dict() should provide "ifname" key for VIFsChristian Poessinger
2022-04-18vxlan: geneve: T4370: support configuration of DF bit optionChristian Poessinger
set interfaces vxlan vxlan0 parameters ip df <set|unset|inherit> set interfaces geneve gnv0 parameters ip df <set|unset|inherit>
2022-04-16vyos.base: use Warning() helper where applicableChristian Poessinger
2022-04-16dhcp(v6)-client: T4353: fix Jinja2 linting errorsChristian Poessinger
2022-04-11T4327: ignore PermissionError caused by ethtool spee/duplex/autoneg settingDaniil Baturin
Certain NICs seem to fail to report that they don't support speed/duplex setting, so they look as if it's supported, but the command fails in practice. It's probably better to preserve a working config in that case.
2022-04-07ipv6: T4346: delete (migrate) CLI command to disable IPv6 address familyChristian Poessinger
2022-04-07qos: T4284: verify mirror/redirect target interface existsChristian Poessinger
2022-04-07qos: T4284: support mirror and redirect on vlan subinterfacesChristian Poessinger
2022-04-07qos: T4284: support mirror and redirect on all interface typesChristian Poessinger
2022-04-05interfaces: T4331: Fix assign link-local static IPv6 addr to vrfViacheslav Hletenko
If we have link-local static address and vrf, for example: set interfaces ethernet eth2 address 'fe80::5200:ff:fe55:222/64' set interfaces ethernet eth2 vrf 'foo' This IPv6 address was assigned before vrf, as result after attaching the intreface to vrf we lose this static linklocal address DEBUG/IFCONFIG cmd 'ip addr add fe80::5200:ff:fe55:222/64 dev eth2' DEBUG/IFCONFIG cmd 'ip link set dev eth2 master foo' DEBUG/IFCONFIG cmd 'ip addr add fe80::5208:ff:fe13:2/64 dev eth2' This commit fixes this, the address is assigned after vrf assign
2022-03-31vyos.ifconfig: T4330: MTU must be configured prior to any IPv6 option changeChristian Poessinger
This extends the fix from 53e20097 ("vyos.ifconfig: T4330: bugfix changing MTU when IPv6 is disabled") by ordering the execution in a way the Kernel does not complain.
2022-03-31vyos.ifconfig: T4330: bugfix changing MTU when IPv6 is disabledChristian Poessinger
Commit f8b3d8999c ("ipv6: T4319: do not configure IPv6 related settings if it's disabled") moved the MTU configuration part under the code path which is only run if IPv6 is enabled on the system. This prevented MTU changes on IPv6 disabled systems.
2022-03-30vyos.ifconfig: T4319: add_addr() should not add IPv6 address if it's disabledChristian Poessinger
2022-03-30vyos.util: T4319: add is_ipv6_enabled() helper functionChristian Poessinger
2022-03-30vyos.ifconfig: make add_addr() method more reader firendlyChristian Poessinger
2022-03-30T4319: do not try to add ::1/128 to lo if IPv6 is disabledDaniil Baturin
2022-03-25ipv6: T4319: do not configure IPv6 related settings if it's disabledChristian Poessinger
2022-03-03interface: T4203: switch to new recursive node_changed() implementationChristian Poessinger
2022-02-21vxlan: T4120: code cleanup for multiple remotesChristian Poessinger
2022-02-20vxlan: T4120: add ability to set multiple remotes (PR #1127)Andreas
VXLAN does support using multiple remotes but VyOS does not. Add the ability to set multiple remotes and add their flood lists using "bridge" command.
2022-02-20interface: T4203: prevent DHCP client restart if not necessaryChristian Poessinger
In the past whenever a change happened to any interface and it was configured as a DHCP client, VyOS always had a breif outage as DHCP released the old lease and re-aquired a new one - bad! This commit changes the behavior that DHCP client is only restarted if any one of the possible options one can set for DHCP client under the "dhcp-options" node is altered.
2022-02-16wireless: T4240: bugfix interface bridgingChristian Poessinger
VLAN isolation can not be "set" when interface is of type wifi.
2022-01-05op-mode: T4142: Fix for show input ifbX interfacesViacheslav
Ability to see interface type "input" ifbX from op-mode
2021-12-31Merge branch 'firewall' of https://github.com/sarthurdev/vyos-1x into currentChristian Poessinger
* 'firewall' of https://github.com/sarthurdev/vyos-1x: zone_policy: T3873: Implement intra-zone-filtering policy: T2199: Migrate policy route op-mode to XML/Python policy: T2199: Migrate policy route to XML/Python zone-policy: T2199: Migrate zone-policy op-mode to XML/Python zone-policy: T2199: Migrate zone-policy to XML/Python firewall: T2199: Migrate firewall op-mode to XML/Python firewall: T2199: Migrate firewall to XML/Python
2021-12-21interface: T4056: Fix unexpected delete tc qdiscViacheslav
Traffic-policy rules are generated by old Perl code This commit prevents to unexpected override this code by python.
2021-12-19vxlan: T3700: add support for Generic Protocol extension (VXLAN-GPE)Christian Poessinger
2021-12-10vxlan: T3700: add support for external controlled FDBChristian Poessinger
Background information [1]. Specifies whether an external control plane (e.g. ip route encap/EVPN) or the internal FDB should be used. [1]: https://legacy.netdevconf.info/2.2/slides/prabhu-linuxbridge-tutorial.pdf
2021-12-06firewall: T2199: Migrate firewall to XML/Pythonsarthurdev
2021-12-06Merge pull request #1077 from sever-sever/T3829Christian Poessinger
netns: T3829: Ability to configure network namespaces
2021-12-03T4035: correct the interface basename extraction logicDaniil Baturin
to avoid confusing 'v' in GENEVE interface prefix ('gnv') with a "vXXX" part of a VRRP interface
2021-11-26netns: T3829: Ability to configure network namespacesViacheslav
2021-11-23netns: T3829: Add netns set section in interface.pyViacheslav
2021-11-19ethernet: T4011: deleting interface should place interface in admin down stateChristian Poessinger
Interface will still be visible to the operating system.
generated by cgit v1.2.3 (git 2.39.1) at 2024-12-17 09:24:14 +0000