Age | Commit message (Collapse) | Author |
|
Limiter in the commit cf92295 was changed to `tbf`
Fix smoketest
|
|
- Migrate to ddclient 3.11.1 and enforce debian/control dependency
- Add dual stack support for additional protocols
- Restrict usage of `porkbun` protocol, VyOS configuration structure
isn't compatible with porkbun yet
- Improve and cleanup error messages
|
|
Time interval in seconds to wait between DNS updates would be a bit
more intuitive as `interval` than `timeout`.
|
|
wireguard: T5707: remove previously deconfigured peer
|
|
Changing the public key of a peer (updating the key material) left the old
WireGuard peer in place, as the key removal command used the new key.
WireGuard only supports peer removal based on the configured public-key, by
deleting the entire interface this is the shortcut instead of parsing out all
peers and removing them one by one.
Peer reconfiguration will always come with a short downtime while the WireGuard
interface is recreated.
|
|
T5698 EVPN ESI Multihoming
|
|
as it's done with facility. Create basic smoketest for syslog
|
|
After commit cc7ba8824 ('vxlan: T5699: migrate "external" CLI know to
"parameters external"') We also need to adjust the testcase for ARP/ND
suppression.
|
|
vxlan: T5668: add CLI knob to enable ARP/ND suppression
|
|
As we have a bunch of options under "paramteres" already and "external" is
clearly one of them it should be migrated under that node as well.
|
|
In order to minimize the flooding of ARP and ND messages in the VXLAN network,
EVPN includes provisions [1] that allow participating VTEPs to suppress such
messages in case they know the MAC-IP binding and can reply on behalf of the
remote host. In Linux, the above is implemented in the bridge driver using a
per-port option called "neigh_suppress" that was added in kernel version 4.15.
[1] https://www.rfc-editor.org/rfc/rfc7432#section-10
|
|
|
|
set interfaces bonding bond10 evpn es-df-pref '50'
set interfaces bonding bond10 evpn es-id '10'
set interfaces bonding bond10 evpn es-sys-mac '01:23:45:67:89:ab'
set interfaces bonding bond10 member interface 'eth3'
set interfaces bonding bond10 mode '802.3ad'
|
|
(valid for interfaces and groups) in firewal, nat and nat66.
|
|
T5643: nat: add interface-groups to nat. Use same cli structure for i…
|
|
Add missed option `ceil` for QoS class 'trafficshaper'
|
|
|
|
T5541: firewall zone: re add firewall zone-base firewall
|
|
T5637: add new rule at the end of base chains for default-actions and log capabilities
|
|
As `providers legacy default` option was deleted with
insecure DES and Blowfish ciphers, the smoketest cannot pass
without adding encyption ciphers
Otherwise
Oct 16 09:41:34 r4 openvpn-vtun5[9648]: DCO version: N/A
Oct 16 09:41:34 r4 openvpn-vtun5[9648]: Cipher BF-CBC not supported
Oct 16 09:41:34 r4 openvpn-vtun5[9648]: Exiting due to fatal error
Fix the smoketest
|
|
|
|
interface-name|interface-group as in firewall.
|
|
T5165: Implement policy local-route source and destination port
|
|
T5530: isis: Adding loop free alternate feature
|
|
pppoe: T5630: allow to specify MRU in addition to already configurable MTU
|
|
enables log capabilities for default-action in base chains. And of course, add option for enabling log for default-action
|
|
Add `policy local-route` source and destination port
set policy local-route rule 23 destination port '222'
set policy local-route rule 23 protocol 'tcp'
set policy local-route rule 23 set table '123'
set policy local-route rule 23 source port '8888'
% ip rule show prio 23
23: from all ipproto tcp sport 8888 dport 222 lookup 123
|
|
|
|
|
|
|
|
Set the MRU (Maximum Receive Unit) value to n. PPPd will ask the peer to send
packets of no more than n bytes. The value of n must be between 128 and 16384,
the default was always 1492 to match PPPoE MTU.
A value of 296 works well on very slow links (40 bytes for TCP/IP header + 256
bytes of data). Note that for the IPv6 protocol, the MRU must be at least 1280.
CLI:
set interfaces pppoe pppoe0 mru 1280
|
|
Add support for per-service cache management for ddclient providers
via `wait-time` and `expiry-time` options. This allows for finer-grained
control over how often a service is updated and how long the hostname
will be cached before being marked expired in ddclient's cache.
More specifically, `wait-time` controls how often ddclient will attempt
to check for a change in the hostname's IP address, and `expiry-time`
controls how often ddclient to a forced update of the hostname's IP
address.
These options intentionally don't have any default values because they
are provider-specific. They get treated similar to the other provider-
specific options in that they are only used if defined.
|
|
T5165: Migrate policy local-route rule x destination to address
|
|
ddclient: T5612: Miscellaneous improvements and fixes for dynamic DNS
|
|
Migrate policy local-route <destination|source> to node address
replace 'policy local-route{v6} rule <tag> destination|source <x.x.x.x>'
=> 'policy local-route{v6} rule <tag> destination|source address <x.x.x.x>'
|
|
filter and in policy route.
|
|
This commit adds a new configuration option to the mDNS repeater service
to allow controlling which IP version to use for mDNS repeater.
Additionally, publishing AAAA record over IPv4 and A record over IPv6 is
disabled as suggested.
See:
- https://github.com/lathiat/avahi/issues/117#issuecomment-1651475104
- https://bugzilla.redhat.com/show_bug.cgi?id=669627#c2
|
|
T5217: Add firewall synproxy
|
|
conntrack: T5376: T5598: Restore kernel conntrack helpers
|
|
firewall: T5614: Add support for matching on conntrack helper
|
|
ipsec: T5606: Add support for whole CA chains
|
|
Add option `protocol` for policy local-route
set policy local-route rule 100 destination '192.0.2.12'
set policy local-route rule 100 protocol 'tcp'
set policy local-route rule 100 set table '100'
|
|
`nf_conntrack_helper` that auto-assigned helpers is removed from the kernel
|
|
|
|
Also includes an update to smoketest to verify
|
|
Additional cleanup and refactoring for ddclient scripts including the
smotektests.
|
|
Some porvides (like 'namecheap') allow to use '@' or '*' as hostname
prefix for apex and wildcard records. This commit relaxes the hostname
validation to allow these prefixes.
|
|
Enable TTL support for web-service based protocols in addition to
RFC2136 based (nsupdate) protocol.
Since TTL is not supported by all protocols, and thus cannot have a
configuration default, the existing XML snippet `include/dns/time-to-live.xml.i`
does not have common `<defaultValue>300</defaultValue>` anymore and is
instead added explicitly whenever necessary.
|
|
Fix VRF support interface definition and configuration mode for ddclient
to actually capture the VRF name and pass it to the template.
|
|
Add ability to SYNPROXY connections
It is useful to protect against TCP SYN flood attacks and port-scanners
set firewall global-options syn-cookies 'enable'
set firewall ipv4 input filter rule 10 action 'synproxy'
set firewall ipv4 input filter rule 10 destination port '22'
set firewall ipv4 input filter rule 10 inbound-interface interface-name 'eth1'
set firewall ipv4 input filter rule 10 protocol 'tcp'
set firewall ipv4 input filter rule 10 synproxy tcp mss '1460'
set firewall ipv4 input filter rule 10 synproxy tcp window-scale '7'
|