| Age | Commit message (Collapse) | Author | |
|---|---|---|---|
| 2024-03-21 | Merge pull request #3158 from c-po/bridge-T6125 | Daniil Baturin | |
| bridge: T6125: support 802.1ad (ethertype 0x88a8) VLAN filtering | |||
| 2024-03-20 | conntrack: T6147: Enable conntrack when firewall state-policy is defined | sarthurdev | |
| * Move global state-policy smoketest to it's own test, verify conntrack | |||
| 2024-03-20 | bridge: T6125: support 802.1ad (ethertype 0x88a8) VLAN filtering | Christian Breunig | |
| Linux bridge uses EtherType 0x8100 by default. In some scenarios, an EtherType value of 0x88A8 is required. Reusing CLI command from VIF-S (QinQ) interfaces: set interfaces bridge br0 protocol 802.1ad | |||
| 2024-03-20 | vti: T6085: interface is always down and only enabled by IPSec daemon | Christian Breunig | |
| When a VTI interface is just created, it is in ADMIN UP state by default, even if an IPSec peer is not connected. After the peer is disconnected the interface goes to DOWN state as expected. This breaks routing logic - for example, static routes through VTI interfaces will be active even if a peer is not connected. This changes to logic so ADMIN UP/DOWN state can only be changed by the vti-up-down helper script. Error was introduced during the Perl -> Python migration and move to the generic vyos.ifconfig abstraction during the 1.4 development cycle. | |||
| 2024-03-20 | bgp: T6106: Valid commit error for route-reflector-client option defined in ↵ | khramshinr | |
| peer-group handle vtysh bgp error | |||
| 2024-03-19 | Merge pull request #3131 from HollyGurza/T1871 | Christian Breunig | |
| qos: T1871: add MTU option when configure limiter traffic-policy | |||
| 2024-03-19 | Merge pull request #3035 from jestabro/replace-backslash | John Estabrook | |
| T5996: selectively escape and restore single backslashes in config | |||
| 2024-03-18 | T5996: add smoketest to check translation of backslash character | John Estabrook | |
| 2024-03-18 | qos: T1871: add MTU option when configure limiter traffic-policy | khramshinr | |
| add mtu to default and specified class update smoke test | |||
| 2024-03-17 | Merge pull request #3139 from c-po/as-path-T6129 | Christian Breunig | |
| policy: T6129: add route-map option "as-path exclude all" | |||
| 2024-03-17 | policy: T6129: add route-map option "as-path exclude all" | Christian Breunig | |
| Remove all AS numbers from the AS_PATH of the BGP path's NLRI. set policy route-map <name> rule <rule> set as-path exclude all | |||
| 2024-03-16 | Merge pull request #3112 from Ingramz/add-rtsp-2 | Christian Breunig | |
| conntrack: T4022: add RTSP conntrack helper | |||
| 2024-03-12 | radvd: T6118: add nat64prefix support RFC8781 | Christian Breunig | |
| Add support for pref64 option, as defined in RFC8781. The prefix valid lifetime must not be smaller than the "interface interval max" definition which defaults to 600. set service router-advert interface eth1 nat64prefix 64:ff9b::/96 | |||
| 2024-03-12 | conntrack: T4022: add RTSP conntrack helper | Indrek Ardel | |
| 2024-03-11 | T5872: re-write exit hook to always regenerate config | Lucas Christian | |
| 2024-03-10 | T5872: ipsec remote access VPN: support dhcp-interface. | Lucas Christian | |
| 2024-03-10 | Merge pull request #3113 from c-po/firewall-T6071 | Daniil Baturin | |
| firewall: T6071: truncate rule description field to 255 characters | |||
| 2024-03-10 | xml: T5738: lower maximum description to 255 characters | Christian Breunig | |
| e.g. Linux Kernel only supports 255 and not 256 characters for the ifalias field. | |||
| 2024-03-07 | Merge pull request #2966 from HollyGurza/T6020 | Daniil Baturin | |
| vrrp: T6020: vrrp health-check script not applied correctly | |||
| 2024-03-07 | snmp: T2998: SNMP v3 oid "exclude" option fix | Nataliia Solomko | |
| 2024-03-05 | T6061: fix rule parsing when connection-status is used | Nicolas Fort | |
| 2024-03-04 | Merge pull request #3078 from c-po/ospfv3-isis-T6087 | Daniil Baturin | |
| ospfv3: T6087: add support to redistribute IS-IS routes | |||
| 2024-03-04 | Merge pull request #3077 from c-po/ethtool | Daniil Baturin | |
| vyos.ethtool: T6083: use JSON input data #2 | |||
| 2024-03-04 | T6086: NAT: fix nat rules when using source-groups and translation address ↵ | Nicolas Fort | |
| is a network. | |||
| 2024-03-03 | ospfv3: T6087: add support to redistribute IS-IS routes | Christian Breunig | |
| 2024-03-03 | smoketest: T4977: ospf: include babel in redistribution tests | Christian Breunig | |
| 2024-03-03 | vyos.ethtool: T6083: use JSON input data for ethernet interface flow-control ↵ | Christian Breunig | |
| settings | |||
| 2024-03-02 | Merge pull request #3073 from c-po/ospfv3-redistribution-T5717 | Christian Breunig | |
| ospfv3: allow metric and metric-type on redistributed routes | |||
| 2024-03-02 | ospfv3: T5717: allow metric and metric-type on redistributed routes | Christian Breunig | |
| Example: vyos@vyos# set protocols ospfv3 redistribute bgp Possible completions: metric OSPF default metric metric-type OSPF metric type for default routes (default: 2) route-map Specify route-map name to use | |||
| 2024-03-01 | vyos.ethtool: T6083: use JSON input data for ring-buffer methods | Christian Breunig | |
| 2024-03-01 | vrrp: T6020: vrrp health-check script not applied correctly in keepalived.conf | khramshinr | |
| Added health-check to sync-group in CLI Don't use instance health-check when instance in sync group member Disallow wrong healtch-check configurations New smoke test | |||
| 2024-02-29 | Merge pull request #3056 from natali-rs1985/T5504-current | Christian Breunig | |
| T5504: Keepalived VRRP ability to set more than one peer-address | |||
| 2024-02-29 | T5504: Added smoketest for multiple peer addresses | Nataliia Solomko | |
| 2024-02-29 | vrrp: T6020: vrrp health-check script not applied correctly in keepalived.conf | khramshinr | |
| Added health-check to sync-group in CLI Don't use instance health-check when instance in sync group member Disallow wrong healtch-check configurations New smoke test | |||
| 2024-02-27 | vrf: conntrack: T6073: Populate VRF zoning chains only while conntrack is ↵ | sarthurdev | |
| required | |||
| 2024-02-27 | smoketest: T5160: Deduplicate nftables verify functions to testcase class, ↵ | sarthurdev | |
| remove obsolete imports | |||
| 2024-02-25 | dhcp-server: T6063: Add `ignore-client-id` to relax client identifier checks ↵ | sarthurdev | |
| for leases | |||
| 2024-02-18 | smoketest: T6043: proper cleanup after testcase | Christian Breunig | |
| This extends commit dbe8c613b ("bridge: T6043: do not call vxlan dependency if interface does not exist (yet)") with a proper cleanup of additional interfaces created during the testrun. | |||
| 2024-02-17 | bridge: T6043: do not call vxlan dependency if interface does not exist (yet) | Christian Breunig | |
| In order to keep the proper priority list during system startup and on initial setup/commit for this feature the dependent VXLAN code should not be called, if the interface in question does not exist (yet). | |||
| 2024-02-17 | Merge pull request #3019 from c-po/login-T5972 | Christian Breunig | |
| login: T5972: add possibility to disable individual local user accounts | |||
| 2024-02-16 | login: T5972: add possibility to disable individual local user accounts | Christian Breunig | |
| * set system login user <name> disable | |||
| 2024-02-16 | Merge pull request #3016 from c-po/nht | Christian Breunig | |
| T6001: add option to disable next-hop-tracking resolve-via-default | |||
| 2024-02-16 | T6001: add option to disable next-hop-tracking resolve-via-default in VRF ↵ | Christian Breunig | |
| context * set vrf name <name> ip nht no-resolve-via-default * set vrf name <name> ipv6 nht no-resolve-via-default | |||
| 2024-02-16 | T6001: add option to disable next-hop-tracking resolve-via-default | Christian Breunig | |
| * set system ip nht no-resolve-via-default * set system ipv6 nht no-resolve-via-default | |||
| 2024-02-15 | Merge pull request #3004 from aapostoliuk/T6029-circinus | Daniil Baturin | |
| T6029: Rewritten Accel-PPP services to an identical feature set | |||
| 2024-02-15 | T6029: Rewritten Accel-PPP services to an identical feature set | aapostoliuk | |
| Removed dhcp-interface option (l2tp) Added wins-server (sstp) Added description (ipoe, pppoe, sstp, pptp) Added exteded-script (l2tp, sstp, pptp) Added shaper (ipoe, pptp, sstp, l2tp) Added limits (ipoe, pptp, sstp, l2tp) Added snmp ( ipoe, pptp,sstp, l2tp) Refactoring and reformated code. | |||
| 2024-02-15 | eigrp: T2472: remove smoketest | Christian Breunig | |
| Commit 0eb4168aa ("eigrp: T2472: improve code for later tests") added a basic smoketest for EIGRP, which is also run by the CI hence not having a +x bit at all. This just deletes the basic smoketest testing for ASN and EIGRP router-id. We can revert it once it's fixed in FRR upstream. https://github.com/FRRouting/frr/pull/14765 | |||
| 2024-02-14 | eigrp: T2472: improve code for later tests | Christian Breunig | |
| 2024-02-13 | T6019: Fix smoketest test_system_conntrack custom timeout | Viacheslav Hletenko | |
| After updateing netfilter in the commit https://github.com/vyos/vyos-build/commit/b31f5fe934bcb37534d49acdb5f7756bf05422e8 The nftables format for conntrack timeouts is different. Fix this. | |||
| 2024-02-13 | Merge pull request #2999 from sever-sever/T5928 | Christian Breunig | |
| T5928: Change firewall priority to 319 | |||
 |
index : vyos-1x.git | |
| VyOS command definitions, scripts, and utilities (mirror of https://github.com/marekm72/vyos-1x.git) |
| summaryrefslogtreecommitdiff |