Age | Commit message (Collapse) | Author | |
---|---|---|---|
2021-01-07 | login: radius: T3192: migrate to get_config_dict() | Christian Poessinger | |
2021-01-07 | ssh: T2635: harden Jinja2 template and daemon startup | Christian Poessinger | |
2021-01-07 | ssh: T2635: change sshd_config path to /run/sshd | Christian Poessinger | |
2021-01-07 | login: radius: T3192: support IPv6 server(s) and source-address | Christian Poessinger | |
2021-01-07 | bgp: T2174: verify() existence of route-map and prefix-list | Christian Poessinger | |
2021-01-06 | bgp: T2174: verify() proper existance of remote-as | Christian Poessinger | |
2021-01-05 | Merge pull request #667 from Cheeze-It/current | Christian Poessinger | |
ISIS: T3156: Adding segment routing for ISIS | |||
2021-01-05 | ISIS: T3156: Adding segment routing for ISIS | Cheeze_It | |
In this commit we add the segment routing portion for ISIS. There's also an additional check that is added so that the global block label ranges are properly configured. Also added traffic engineering configurations as well. | |||
2021-01-03 | mirror: add verify() check so we can not mirror back to our self | Christian Poessinger | |
2021-01-03 | dhcp: T2562: harden implementation for non existing shared-subnets | Christian Poessinger | |
2021-01-03 | dhcp: T3180: bugfix assignment of sliced ranges to config dict | Christian Poessinger | |
A reference to a dictionary key obtained by a for loop can not be used to update values inside that dictionaries key. You must use the original path to the nested dictionaries key. | |||
2021-01-03 | dhcp: T3180: bugfix NameError when slicing server ranges | Christian Poessinger | |
Introduced in commit e46def834483e ("dhcp: T3100: re-add range slicing support when exclude addresses are used") by not obeying the move from list to dict and still relying on the old list names variables. | |||
2021-01-02 | vrf: T2321: assign loopback IP addresses to individual VRF interfaces | Christian Poessinger | |
47: bar: <NOARP,MASTER,UP,LOWER_UP> mtu 65536 qdisc noqueue state UP group default qlen 1000 link/ether 76:7d:c0:53:6d:89 brd ff:ff:ff:ff:ff:ff inet 127.0.0.1/8 scope host bar valid_lft forever preferred_lft forever inet6 ::1/128 scope host valid_lft forever preferred_lft forever | |||
2021-01-01 | ethernet: T3171: add CLI option to enable RPS (Receive Packet Steering) | Christian Poessinger | |
set interfaces ethernet <interface> offload rps | |||
2020-12-31 | openvpn: T2994: fix ipv6 server mode | Christian Poessinger | |
2020-12-29 | ethernet: T1466: add EAPoL support | Christian Poessinger | |
2020-12-28 | webproxy: T563: squidguard: support default ruleset | Christian Poessinger | |
2020-12-28 | webproxy: T563: add squidguard body | Christian Poessinger | |
2020-12-28 | webproxy: T563: improve handling of cache-peers | Christian Poessinger | |
2020-12-28 | webproxy: T563: migrate from old Perl code to XML and get_config_dict() | Christian Poessinger | |
Basic proxy functionality is working but the squidguard smoketest still fails as this is yet not implemented. | |||
2020-12-23 | xdp: T2666: move CLI node to "interfaces ethernet <eth> xdp" | Christian Poessinger | |
2020-12-23 | xdp: T2666: require at least 2 TX queues | Christian Poessinger | |
2020-12-17 | flow-accounting: T3132: enable egress traffic accounting | Jan-Philipp Benecke | |
2020-12-08 | bgp: T2174: Fix Template. Update to use FRRConfig framework | sever-sever | |
2020-12-07 | system: T3119: migrate "system ip" to get_config_dict() incl. smoketest | Christian Poessinger | |
2020-12-07 | Merge pull request #636 from c-po/t2562-dhcp | Christian Poessinger | |
dhcp: T2562: add "listen-address" CLI node for better DHCP relay support | |||
2020-12-06 | dhcpv6-relay: T3095: is_ipv6_link_local() now supports a prefix length | Christian Poessinger | |
2020-12-06 | dhcpv6: T3100: migrate server configuration to get_config_dict() | Christian Poessinger | |
2020-12-06 | dhcp: T2562: add "listen-address" CLI node for better DHCP relay support | Christian Poessinger | |
Running ISC DHCP server as backend server for multiple pools served to relay agents requires DHCPd to explicitly listen on give interfaces or a "transit" subnet declaration facing the network where we receive the DHCPREQ messages on. This implements a new "listen-address" CLI node, the given address is validated if it is assigned to the system and upon success, a proper "subnet { }" statement is added into dhcpd.conf | |||
2020-12-04 | dhcp: T3100: re-add range slicing support when exclude addresses are used | Christian Poessinger | |
Support was not yet present after the rewrite from commit 84b7ade2 ("dhcp: T3100: migrate server configuration to get_config_dict()") | |||
2020-12-04 | dhcp: T3100: migrate server configuration to get_config_dict() | Christian Poessinger | |
2020-12-03 | pim: igmp: T2744: Define the absolute path to pimd | DmitriyEshenko | |
2020-12-03 | isis: T1316: Fix isis delete section. Use an updated frr framework | sever-sever | |
2020-12-01 | nat: T3102: Check key in dictionary | DmitriyEshenko | |
2020-12-01 | vpn: ipsec: T3093: add XML for vpn ipsec conf-mode | Viacheslav Hletenko | |
2020-12-01 | dhcpv6: T1433: combine templates for v4 and v6 | Christian Poessinger | |
2020-11-30 | Merge pull request #624 from Cheeze-It/current | Christian Poessinger | |
mpls-conf: T915: Add ethernet vif sub interface MPLS enable | |||
2020-11-30 | mpls-conf: T915: Add ethernet vif MPLS enable | Cheeze_It | |
In this commit we added ethernet sub interface MPLS enablement. Per request by @bbs2web, this functionality is now possible. This should now allow ethernet switched networks with VLAN tags to also allow for MPLS packet flow. | |||
2020-11-30 | Merge pull request #612 from sever-sever/T1316 | Daniil Baturin | |
frr-isis: T1316: Add new routing feature ISIS | |||
2020-11-30 | frr-is-is: T1316: Add new routing feature IS-IS | sever-sever | |
2020-11-29 | dhcpv6-relay: T3095: improve verify() | Christian Poessinger | |
- Upstream interfaces require a DHCPv6 server to be configured - Listen interface must have a a global unicast address assigned, else ISC dhcrelay won't start. | |||
2020-11-29 | dhcpv6-relay: T3095: migrate service to get_config_dict() | Christian Poessinger | |
2020-11-29 | smoketest: dhcpv6-relay: T3095: initial tests | Christian Poessinger | |
2020-11-29 | dhcp-relay: T3095: migrate service to get_config_dict() | Christian Poessinger | |
2020-11-29 | smoketest: dhcp-relay: T3095: initial tests | Christian Poessinger | |
2020-11-28 | nat: T3092: migrate to get_config_dict() | Christian Poessinger | |
The NAT system consists out of nested tag nodes which makes manual parsing very hard. This is a perfect candidate for migrating this to get_config_dict() as there is already a smoketest in place. In addition this should make it easier to add features like static nat/hairpin. | |||
2020-11-28 | system: T3038: remove /dev/console from loadkeys | Christian Poessinger | |
/dev/console is not always present, e.g. on headless devices like an APU4. | |||
2020-11-27 | vyos.template: T2720: always enable Jinja2 trim_blocks feature | Christian Poessinger | |
2020-11-27 | igmp-proxy: T3088: migrate to get_config_dict() | Christian Poessinger | |
2020-11-26 | pim: igmp: igmp-proxy: T2744: Add check to prevent pimd and igmp-proxy conflict | DmitriyEshenko | |