From 6f87d8c910964fd0ebe9724183baa12861caa419 Mon Sep 17 00:00:00 2001
From: Christian Poessinger <christian@poessinger.com>
Date: Sun, 15 Aug 2021 12:53:03 +0200
Subject: ospf: T3757: support to configure area at an interface level

FRR supports configuring either network prefixes per area, or assign an
interface to an area to participate in the routing process. This is already well
known from other venders and supported by FRR.

A valid VyOS OSPF configuration would then look like:

vyos@vyos# show protocols
 ospf {
     interface dum0 {
         area 0
     }
     interface eth0.201 {
         area 0
         authentication {
             md5 {
                 key-id 10 {
                     md5-key vyos
                 }
             }
         }
         dead-interval 40
         hello-interval 10
         priority 1
         retransmit-interval 5
         transmit-delay 1
     }
     log-adjacency-changes {
         detail
     }
     parameters {
         abr-type cisco
         router-id 172.18.254.201
     }
     passive-interface default
     passive-interface-exclude eth0.201
 }
---
 src/conf_mode/protocols_ospf.py | 9 +++++++++
 1 file changed, 9 insertions(+)

(limited to 'src/conf_mode/protocols_ospf.py')

diff --git a/src/conf_mode/protocols_ospf.py b/src/conf_mode/protocols_ospf.py
index 82126cb11..a21ea6c9f 100755
--- a/src/conf_mode/protocols_ospf.py
+++ b/src/conf_mode/protocols_ospf.py
@@ -157,6 +157,15 @@ def verify(ospf):
                 raise ConfigError(f'Can not use hello-multiplier and dead-interval ' \
                                   f'concurrently for {interface}!')
 
+            # One can not use the "network <prefix> area <id>" command and an
+            # per interface area assignment at the same time. FRR will error
+            # out using: "Please remove all network commands first."
+            if 'area' in ospf:
+                for area, area_config in ospf['area'].items():
+                    if 'network' in area_config:
+                        raise ConfigError('Can not use OSPF interface area and area ' \
+                                          'network configuration at the same time!')
+
             if 'vrf' in ospf:
             # If interface specific options are set, we must ensure that the
             # interface is bound to our requesting VRF. Due to the VyOS
-- 
cgit v1.2.3