wwan: add op-mode command definitions

(cherry picked from commit f55f079500f89302ba50ab6b547c31d5fd3d3227)

1 files changed, 233 insertions, 4 deletions

diff --git a/docs/configuration/interfaces/wwan.rst b/docs/configuration/interfaces/wwan.rst
index e1728b56..faeb08ff 100644
--- a/docs/configuration/interfaces/wwan.rst
+++ b/docs/configuration/interfaces/wwan.rst
@@ -68,16 +68,225 @@ WirelessModem (WWAN) options
 
 .. cfgcmd:: set interfaces wwan <interface> apn <apn>
 
-   Every WWAN connection requires an :abbr:`APN (Access Point Name)` which is
-   used by the client to dial into the ISPs network. This is a mandatory
-   parameter. Contact your Service Provider for correct APN.
+  Every WWAN connection requires an :abbr:`APN (Access Point Name)` which is
+  used by the client to dial into the ISPs network. This is a mandatory
+  parameter. Contact your Service Provider for correct APN.
 
 
 *********
 Operation
 *********
 
-TBD
+.. opcmd:: show interfaces wwan <interface>
+
+  Show detailed information on given `<interface>`
+
+  .. code-block::
+
+    vyos@vyos:~$ show interfaces wwan wwan0
+    wwan0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UNKNOWN group default qlen 1000
+        link/ether 02:c2:f3:00:01:02 brd ff:ff:ff:ff:ff:ff
+        inet 10.155.144.12/30 brd 10.155.144.15 scope global dynamic wwan0
+           valid_lft 7012sec preferred_lft 7012sec
+        inet6 fe80::c2:f3ff:fe00:0102/64 scope link
+           valid_lft forever preferred_lft forever
+
+        RX:  bytes  packets  errors  dropped  overrun       mcast
+               640        2       0        0        0           0
+        TX:  bytes  packets  errors  dropped  carrier  collisions
+              3229       16       0        0        0           0
+
+.. opcmd:: show interfaces wwan <interface> summary
+
+  Show detailed information summary on given `<interface>`
+
+  .. code-block::
+
+    vyos@vyos:~$ show interfaces wwan wwan0 summary
+      --------------------------------
+      General  |            dbus path: /org/freedesktop/ModemManager1/Modem/0
+               |            device id: 79f4e9cc2e9fc8d4a3b8c8f6327c2e363170194d
+      --------------------------------
+      Hardware |         manufacturer: Sierra Wireless, Incorporated
+               |                model: MC7710
+               |             revision: SWI9200X_03.05.29.03ap r6485 CNSHZ-ED-XP0031 2014/12/02 17:53:15
+               |         h/w revision: 1.0
+               |            supported: gsm-umts, lte
+               |              current: gsm-umts, lte
+               |         equipment id: 358xxxxxxxxxxxx
+      --------------------------------
+      System   |               device: /sys/devices/pci0000:00/0000:00:13.0/usb3/3-1/3-1.3
+               |              drivers: qcserial, qmi_wwan
+               |               plugin: Generic
+               |         primary port: cdc-wdm0
+               |                ports: ttyUSB0 (qcdm), ttyUSB2 (at), cdc-wdm0 (qmi), wwan0 (net)
+      --------------------------------
+      Numbers  |                  own: 4917xxxxxxxx
+      --------------------------------
+      Status   |                 lock: sim-pin2
+               |       unlock retries: sim-pin (3), sim-pin2 (3), sim-puk (10), sim-puk2 (10)
+               |                state: connected
+               |          power state: on
+               |          access tech: lte
+               |       signal quality: 63% (recent)
+      --------------------------------
+      Modes    |            supported: allowed: 2g; preferred: none
+               |                       allowed: 3g; preferred: none
+               |                       allowed: 4g; preferred: none
+               |                       allowed: 2g, 3g; preferred: 3g
+               |                       allowed: 2g, 3g; preferred: 2g
+               |                       allowed: 2g, 4g; preferred: 4g
+               |                       allowed: 2g, 4g; preferred: 2g
+               |                       allowed: 3g, 4g; preferred: 3g
+               |                       allowed: 3g, 4g; preferred: 4g
+               |                       allowed: 2g, 3g, 4g; preferred: 4g
+               |                       allowed: 2g, 3g, 4g; preferred: 3g
+               |                       allowed: 2g, 3g, 4g; preferred: 2g
+               |              current: allowed: 2g, 3g, 4g; preferred: 2g
+      --------------------------------
+      Bands    |            supported: egsm, dcs, pcs, utran-1, utran-8, eutran-1, eutran-3,
+               |                       eutran-7, eutran-8, eutran-20
+               |              current: egsm, dcs, pcs, utran-1, utran-8, eutran-1, eutran-3,
+               |                       eutran-7, eutran-8, eutran-20
+      --------------------------------
+      IP       |            supported: ipv4, ipv6, ipv4v6
+      --------------------------------
+      3GPP     |                 imei: 358xxxxxxxxxxxx
+               |          operator id: 26201
+               |        operator name: Telekom.de
+               |         registration: home
+      --------------------------------
+      3GPP EPS | ue mode of operation: ps-1
+      --------------------------------
+      SIM      |            dbus path: /org/freedesktop/ModemManager1/SIM/0
+      --------------------------------
+      Bearer   |            dbus path: /org/freedesktop/ModemManager1/Bearer/0
+
+
+.. opcmd:: show interfaces wwan <interface> capabilities
+
+  Show WWAN module hardware capabilities.
+
+  .. code-block::
+
+    vyos@vyos:~$ show interfaces wwan wwan0 capabilities
+    Max TX channel rate: '50000000'
+    Max RX channel rate: '100000000'
+    Data Service: 'simultaneous-cs-ps'
+    SIM: 'supported'
+    Networks: 'gsm, umts, lte'
+    Bands: 'gsm-dcs-1800, gsm-900-extended, gsm-900-primary, gsm-pcs-1900, wcdma-2100, wcdma-900'
+    LTE bands: '1, 3, 7, 8, 20'
+
+.. opcmd:: show interfaces wwan <interface> firmware
+
+  Show WWAN module firmware.
+
+  .. code-block::
+
+    vyos@vyos:~$ show interfaces wwan wwan0 firmware
+    Model: MC7710
+    Boot version: SWI9200X_03.05.29.03bt r6485 CNSHZ-ED-XP0031 2014/12/02 17:33:08
+    AMSS version: SWI9200X_03.05.29.03ap r6485 CNSHZ-ED-XP0031 2014/12/02 17:53:15
+    SKU ID: unknown
+    Package ID: unknown
+    Carrier ID: 0
+    Config version: unknown
+
+
+.. opcmd:: show interfaces wwan <interface> imei
+
+  Show WWAN module IMEI.
+
+  .. code-block::
+
+    vyos@vyos:~$ show interfaces wwan wwan0 imei
+    ESN: '0'
+    IMEI: '358xxxxxxxxxxxx'
+    MEID: 'unknown'
+
+.. opcmd:: show interfaces wwan <interface> imsi
+
+  Show WWAN module IMSI.
+
+  .. code-block::
+
+    vyos@vyos:~$ show interfaces wwan wwan0 imsi
+    IMSI: '262xxxxxxxxxxxx'
+
+.. opcmd:: show interfaces wwan <interface> model
+
+  Show WWAN module model.
+
+  .. code-block::
+
+    vyos@vyos:~$ show interfaces wwan wwan0 model
+    Model: 'MC7710'
+
+.. opcmd:: show interfaces wwan <interface> msisdn
+
+  Show WWAN module MSISDN.
+
+  .. code-block::
+
+    vyos@vyos:~$ show interfaces wwan wwan0 msisdn
+    MSISDN: '4917xxxxxxxx'
+
+.. opcmd:: show interfaces wwan <interface> revision
+
+  Show WWAN module hardware revision.
+
+  .. code-block::
+
+    vyos@vyos:~$ show interfaces wwan wwan0 revision
+    Revision: 'SWI9200X_03.05.29.03ap r6485 CNSHZ-ED-XP0031 2014/12/02 17:53:15'
+
+.. opcmd:: show interfaces wwan <interface> signal
+
+  Show WWAN module signal strength.
+
+  .. code-block::
+
+    vyos@vyos:~$ show interfaces wwan wwan0 signal
+    LTE:
+    RSSI: '-74 dBm'
+    RSRQ: '-7 dB'
+    RSRP: '-100 dBm'
+    SNR: '13.0 dB'
+    Radio Interface:   'lte'
+    Active Band Class: 'eutran-3'
+    Active Channel:    '1300'
+
+.. opcmd:: show interfaces wwan <interface> sim
+
+  Show WWAN module SIM card information.
+
+  .. code-block::
+
+    vyos@vyos:~$ show interfaces wwan wwan0 sim
+    Provisioning applications:
+    Primary GW:   slot '1', application '1'
+    Primary 1X:   session doesn't exist
+    Secondary GW: session doesn't exist
+    Secondary 1X: session doesn't exist
+    Slot [1]:
+    Card state: 'present'
+    UPIN state: 'not-initialized'
+    UPIN retries: '0'
+    UPUK retries: '0'
+    Application [1]:
+    Application type:  'usim (2)'
+    Application state: 'ready'
+    Application ID:
+    A0:00:00:00:87:10:02:FF:49:94:20:89:03:10:00:00
+    Personalization state: 'ready'
+    UPIN replaces PIN1: 'no'
+    PIN1 state: 'disabled'
+    PIN1 retries: '3'
+    PUK1 retries: '10'
+    PIN2 state: 'enabled-not-verified'
+    PIN2 retries: '3'
+    PUK2 retries: '10'
 
 *******
 Example
@@ -105,3 +314,23 @@ The following hardware modules have been tested successfully in an
 * Sierra Wireless AirPrime MC7710 miniPCIe card (LTE)
 * Huawei ME909u-521 miniPCIe card (LTE)
 * Huawei ME909s-120 miniPCIe card (LTE)
+
+***************
+Firmware Update
+***************
+
+All available WWAN cards have a build in, reprogrammable firmware. Most of the
+vendors provide a regular update to the firmware used in the baseband chip.
+
+As VyOS makes use of the QMI interface to connect to the WWAN modem cards, also
+the firmware can be reprogrammed.
+
+To update the firmware, VyOS also ships the `qmi-firmware-update` binary. To
+upgrade the firmware of an e.g. Sierra Wireless MC7710 module to the firmware
+provided in the file ``9999999_9999999_9200_03.05.14.00_00_generic_000.000_001_SPKG_MC.cwe``
+use the following command:
+
+.. code-block:: bash
+
+  $ sudo qmi-firmware-update --update -d 1199:68a2 \
+     9999999_9999999_9200_03.05.14.00_00_generic_000.000_001_SPKG_MC.cwe