diff options
| -rw-r--r-- | README.md | 2 | ||||
| -rw-r--r-- | docs/configuration/interfaces/pppoe.rst | 36 |
2 files changed, 20 insertions, 18 deletions
@@ -62,7 +62,7 @@ Then run: sudo pip install sphinx-rtd-theme ``` -Do the following to build the HTML and start a webserver: +Do the following to build the HTML and start a web server: * Run `make livehtml` inside the `docs` folder Then, to view the live output: diff --git a/docs/configuration/interfaces/pppoe.rst b/docs/configuration/interfaces/pppoe.rst index 4a31efc5..e1bb3056 100644 --- a/docs/configuration/interfaces/pppoe.rst +++ b/docs/configuration/interfaces/pppoe.rst @@ -115,24 +115,26 @@ PPPoE options timeout period, after which an idle PPPoE link will be disconnected. A non-zero idle timeout will never disconnect the link after it first came up. -.. cfgcmd:: set interfaces pppoe <interface> default-route [auto | force | none] +.. cfgcmd:: set interfaces pppoe <interface> no-default-route - Use this command to specify whether to automatically add a default route - pointing to the endpoint of the PPPoE when the link comes up. The default - route is only added if no other default route already exists in the system. + Only request an address from the PPPoE server but do not install any default + route. - **default:** A default route to the remote endpoint is automatically added - when the link comes up (i.e. auto). + Example: - * auto: A default route is added if no other default route (From any - source) already exists. - * force: A default route is added after removing *all* existing default - routes. - * none: No default route is installed. + .. code-block:: none + + set interfaces pppoe pppoe0 no-default-route + +.. cfgcmd:: set interfaces pppoe <interface> default-route-distance <distance> + + Set the distance for the default gateway sent by the PPPoE server. -.. note:: In all modes except 'none', all default routes using this interface - will be removed when the interface is torn down - even manually installed - static routes. + Example: + + .. code-block:: none + + set interfaces pppoe pppoe0 default-route-distance 220 .. cfgcmd:: set interfaces pppoe <interface> idle-timeout <time> @@ -190,7 +192,7 @@ PPPoE options .. hint:: MSS value = MTU - 20 (IP header) - 20 (TCP header), resulting in 1452 bytes on a 1492 byte MTU. - Instead of a numerical MSS value `clamp-mss-to-pmtu` can be used to + Instead of a numerical MSS value `clamp-mss-to-pmtu` can be used to automatically set the proper value. .. cfgcmd:: set interfaces pppoe <interface> ip disable-forwarding @@ -235,8 +237,8 @@ IPv6 .. hint:: MSS value = MTU - 20 (IP header) - 20 (TCP header), resulting in 1452 bytes on a 1492 byte MTU. - - Instead of a numerical MSS value `clamp-mss-to-pmtu` can be used to + + Instead of a numerical MSS value `clamp-mss-to-pmtu` can be used to automatically set the proper value. .. cfgcmd:: set interfaces pppoe <interface> ipv6 disable-forwarding |