diff options
| -rw-r--r-- | docs/configuration/protocols/ospf.rst | 26 |
1 files changed, 22 insertions, 4 deletions
diff --git a/docs/configuration/protocols/ospf.rst b/docs/configuration/protocols/ospf.rst index bb67653e..e3f9759e 100644 --- a/docs/configuration/protocols/ospf.rst +++ b/docs/configuration/protocols/ospf.rst @@ -38,10 +38,10 @@ starts when the first ospf enabled interface is configured. specified in decimal notation in the range from 0 to 4294967295. Or it can be specified in dotted decimal notation similar to ip address. - Prefix length in interface must be equal or bigger (i.e. smaller network) than - prefix length in network statement. For example statement above doesn't enable - ospf on interface with address 192.168.1.1/23, but it does on interface with - address 192.168.1.129/25. + Prefix length in interface must be equal or bigger (i.e. smaller network) + than prefix length in network statement. For example statement above doesn't + enable ospf on interface with address 192.168.1.1/23, but it does on + interface with address 192.168.1.129/25. In some cases it may be more convenient to enable OSPF on a per interface/subnet basis :cfgcmd:`set protocols ospf interface <interface> area <x.x.x.x | x>` @@ -162,6 +162,12 @@ Optional interfaces where router adjacencies are expected need to be configured with the :cfgcmd:`passive-interface-exclude` command. +.. cfgcmd:: set protocols ospf maximum-paths <1-64> + + Use this command to control the maximum number of equal cost paths to reach + a specific destination. The upper limit may differ if you change the value + of MULTIPATH_NUM during compilation. The default is MULTIPATH_NUM (64). + .. cfgcmd:: set protocols ospf refresh timers <seconds> The router automatically updates link-state information with its neighbors. @@ -271,6 +277,18 @@ Area Configuration intra area paths from this range are not advertised into other areas. This command makes sense in ABR only. +.. cfgcmd:: set protocols ospf area <number> export-list <acl_number> + + Filter Type-3 summary-LSAs announced to other areas originated from + intra- area paths from specified area. + This command makes sense in ABR only. + +.. cfgcmd:: set protocols ospf area <number> import-list <acl_number> + + Same as export-list, but it applies to paths announced into specified + area as Type-3 summary-LSAs. + This command makes sense in ABR only. + .. cfgcmd:: set protocols ospf area <number> range <A.B.C.D/M> substitute <E.F.G.H/M> |