diff options
Diffstat (limited to 'docs/interfaces/pppoe.rst')
| -rw-r--r-- | docs/interfaces/pppoe.rst | 12 |
1 files changed, 6 insertions, 6 deletions
diff --git a/docs/interfaces/pppoe.rst b/docs/interfaces/pppoe.rst index 803b43fb..d8625722 100644 --- a/docs/interfaces/pppoe.rst +++ b/docs/interfaces/pppoe.rst @@ -22,7 +22,7 @@ Once you have an Ethernet device connected, i.e. eth0, then you can configure it **Here is an example configuration:** -.. code-block:: console +.. code-block:: none set interface ethernet eth0 description "DSL Modem" set interface ethernet eth0 duplex auto @@ -37,7 +37,7 @@ Once you have an Ethernet device connected, i.e. eth0, then you can configure it * You should add a firewall to your configuration above as well by assigning it to the pppoe0 itself as shown here: -.. code-block:: console +.. code-block:: none set interface ethernet eth0 pppoe 0 firewall in name NET-IN set interface ethernet eth0 pppoe 0 firewall local name NET-LOCAL @@ -52,7 +52,7 @@ Handling and troubleshooting You can test connecting and disconnecting with the below commands: -.. code-block:: console +.. code-block:: none disconnect interface 0 connect interface 0 @@ -62,20 +62,20 @@ You can check the PPPoE connection logs with the following: This command shows the current statistics, status and some of the settings (i.e. MTU) for the current connection on pppoe0. -.. code-block:: console +.. code-block:: none show interfaces pppoe 0 This command shows the entire log for the PPPoE connection starting with the oldest data. Scroll down with the <space> key to reach the end where the current data is. -.. code-block:: console +.. code-block:: none show interfaces pppoe 0 log This command shows the same log as without the 'tail' option but only starts with the last few lines and continues to show added lines until you exit with ``Ctrl + x`` -.. code-block:: console +.. code-block:: none show interfaces pppoe 0 log tail |