From 6ffa0359b073b9dc8c27ac3a64763fb8ac41fbbd Mon Sep 17 00:00:00 2001 From: Robert Göhler Date: Thu, 24 Mar 2022 07:23:39 +0100 Subject: raid: fix op command syntax --- docs/operation/raid.rst | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/docs/operation/raid.rst b/docs/operation/raid.rst index 49463a72..30407718 100644 --- a/docs/operation/raid.rst +++ b/docs/operation/raid.rst @@ -154,7 +154,7 @@ To replace a bad disk within a RAID 1 set, perform the following steps: 1 - Remove the failed disk from the RAID 1 set by issuing the following command: -.. opcmd:: delete raid RAID‐1‐device member disk‐partition +.. opcmd:: delete raid member where RAID-1-device is the name of the RAID 1 device (for example, md0) and disk-partition is the name of the failed disk partition (for example, sdb2). @@ -166,7 +166,7 @@ hot-swappable, then you must shut down the system before removing the disk. 4 - Format the new disk for RAID 1 by issuing the following command: -.. opcmd:: format like +.. opcmd:: format disk like where disk-device1 is the replacement disk (for example, sdb) and disk-device2 is the existing healthy disk (for example, sda). @@ -191,7 +191,7 @@ mirror synchronization, check and display information. disk partition to a RAID 1 set initiates mirror synchronization, where all data on the existing member partition is copied to the new partition. -.. opcmd:: format like +.. opcmd:: format disk like This command is typically used to prepare a disk to be added to a preexisting RAID 1 set (of which disk-device2 is already a member). -- cgit v1.2.3