Routing-policy -------------- Routing Policies could be used to tell the router (self or neighbors) what routes and their attributes needs to be put into the routing table. There could be a wide range of routing policies. Some examples are below: * Set some metric to routes learned from a particular neighbor * Set some attributes (like AS PATH or Community value) to advertised routes to neighbors * Prefer a specific routing protocol routes over another routing protocol running on the same router Routing Policy Example ~~~~~~~~~~~~~~~~~~~~~~ **Policy definition:** .. code-block:: none #Create policy set policy route-map setmet rule 2 action 'permit' set policy route-map setmet rule 2 set as-path-prepend '2 2 2' #Apply policy to BGP set protocols bgp 1 neighbor 1.1.1.2 address-family ipv4-unicast route-map import 'setmet' set protocols bgp 1 neighbor 1.1.1.2 address-family ipv4-unicast soft-reconfiguration 'inbound' <<<< *** *** get policy update without bouncing the neighbor **Routes learned before routing policy applied:** .. code-block:: none vyos@vos1:~$ show ip bgp BGP table version is 0, local router ID is 192.168.56.101 Status codes: s suppressed, d damped, h history, * valid, > best, i - internal, r RIB-failure, S Stale, R Removed Origin codes: i - IGP, e - EGP, ? - incomplete Network Next Hop Metric LocPrf Weight Path *> 22.22.22.22/32 1.1.1.2 1 0 2 i < Path Total number of prefixes 1 **Routes learned after routing policy applied:** .. code-block:: none vyos@vos1:~$ sho ip b BGP table version is 0, local router ID is 192.168.56.101 Status codes: s suppressed, d damped, h history, * valid, > best, i - internal, r RIB-failure, S Stale, R Removed Origin codes: i - IGP, e - EGP, ? - incomplete Network Next Hop Metric LocPrf Weight Path *> 22.22.22.22/32 1.1.1.2 1 0 2 2 2 2 i < longer AS_path length Total number of prefixes 1 vyos@vos1:~$