#
# General settings
#
General {
	#
	# Number of buckets in the caches: hash table
	#
	HashSize 8192

	#
	# Maximum number of conntracks: 
	# it must be >= $ cat /proc/sys/net/ipv4/netfilter/ip_conntrack_max
	#
	HashLimit 65535

	#
	# Logfile: on (/var/log/conntrackd.log), off, or a filename
	# Default: off
	#
	#LogFile on

	#
	# Syslog: on, off or a facility name (daemon (default) or local0..7)
	# Default: off
	#
	#Syslog on

	#
	# Lockfile
	# 
	LockFile /var/lock/conntrack.lock

	#
	# Unix socket configuration
	#
	UNIX {
		Path /tmp/sync.sock
		Backlog 20
	}

	#
	# Netlink socket buffer size
	#
	SocketBufferSize 262142

	#
	# Increase the socket buffer up to maximun if required
	#
	SocketBufferSizeMaxGrown 655355

	#
	# Event filtering: This clause allows you to filter certain traffic,
	# There are currently three filter-sets: Protocol, Address and
	# State. The filter is attached to an action that can be: Accept or
	# Ignore. Thus, you can define the event filtering policy of the
	# filter-sets in positive or negative logic depending on your needs.
	#
	Filter {
		#
		# Accept only certain protocols: You may want to log the
		# state of flows depending on their layer 4 protocol.
		#
		Protocol Accept {
			TCP
		}

		#
		# Ignore traffic for a certain set of IP's.
		#
		Address Ignore {
			IPv4_address 127.0.0.1 # loopback
		}

		#
		# Uncomment this line below if you want to filter by flow state.
		# The existing TCP states are: SYN_SENT, SYN_RECV, ESTABLISHED,
		# FIN_WAIT, CLOSE_WAIT, LAST_ACK, TIME_WAIT, CLOSED, LISTEN.
		#
		# State Accept {
		#	ESTABLISHED CLOSED TIME_WAIT CLOSE_WAIT for TCP
		# }
	}
}

Stats {
	#
	# If you enable this option, the daemon writes the information about
	# destroyed connections to a logfile. Default is off.
	# Logfile: on, off, or a filename
	# Default file: (/var/log/conntrackd-stats.log)
	#
	LogFile on

	#
	# Enable connection logging via Syslog. Default is off.
	# Syslog: on, off or a facility name (daemon (default) or local0..7)
	# If you set the facility, use the same as in the General clause, 
	# otherwise you'll get a warning message.
	#
	#Syslog on
}