diff options
Diffstat (limited to 'data/templates/wifi/hostapd.conf.tmpl')
| -rw-r--r-- | data/templates/wifi/hostapd.conf.tmpl | 23 |
1 files changed, 23 insertions, 0 deletions
diff --git a/data/templates/wifi/hostapd.conf.tmpl b/data/templates/wifi/hostapd.conf.tmpl index 132c4ce40..c5e4240d1 100644 --- a/data/templates/wifi/hostapd.conf.tmpl +++ b/data/templates/wifi/hostapd.conf.tmpl @@ -11,6 +11,21 @@ device_name={{ description | truncate(32, True) }} # command line parameter. interface={{ ifname }} +{% if is_bridge_member is defined %} +# In case of atheros and nl80211 driver interfaces, an additional +# configuration parameter, bridge, may be used to notify hostapd if the +# interface is included in a bridge. This parameter is not used with Host AP +# driver. If the bridge parameter is not set, the drivers will automatically +# figure out the bridge interface (assuming sysfs is enabled and mounted to +# /sys) and this parameter may not be needed. +# +# For nl80211, this parameter can be used to request the AP interface to be +# added to the bridge automatically (brctl may refuse to do this before hostapd +# has been started to change the interface mode). If needed, the bridge +# interface is also created. +bridge={{ is_bridge_member }} +{% endif %} + # Driver interface type (hostap/wired/none/nl80211/bsd); # default: hostap). nl80211 is used with all Linux mac80211 drivers. # Use driver=none if building hostapd as a standalone RADIUS server that does @@ -433,6 +448,14 @@ macaddr_acl=0 max_num_sta={{ max_stations }} {% endif %} +{% if wds is defined %} +# WDS (4-address frame) mode with per-station virtual interfaces +# (only supported with driver=nl80211) +# This mode allows associated stations to use 4-address frames to allow layer 2 +# bridging to be used. +wds_sta=1 +{% endif %} + {% if isolate_stations is defined %} # Client isolation can be used to prevent low-level bridging of frames between # associated stations in the BSS. By default, this bridging is allowed. |