summaryrefslogtreecommitdiff
AgeCommit message (Collapse)Author
2020-11-14Revert "T3068: Automatic generation of IPv6 link local addresses for tunnel ↵Christian Poessinger
interfaces"
2020-11-14Merge pull request #608 from DmitriyEshenko/kb-layoutChristian Poessinger
system: T3038: Add keyboard layout CLI command
2020-11-14Merge pull request #607 from ernstjo/T2802Daniil Baturin
T2802: Tunnel interface does not apply EUI-64 IPv6 Address
2020-11-13system: T3038: Add keyboard layout CLI commandDmitriyEshenko
2020-11-13T2802: Tunnel interface does not apply EUI-64 IPv6 Addressernstjo
Generate an IPv6 Link Local address for wireguard interfaces.
2020-11-13Merge branch 't1316-frr-isis' of github.com:c-po/vyos-1x into currentChristian Poessinger
* 't1316-frr-isis' of github.com:c-po/vyos-1x: isis: T1316: refactor config retrieval and Jinja2 template isis: T1316: October steps
2020-11-13isis: T1316: refactor config retrieval and Jinja2 templateChristian Poessinger
Make the entire template code more human readable by denesting it, as there can only be one ISIS daemon instance in FRR.
2020-11-13Merge pull request #602 from DmitriyEshenko/fix-op-rebootChristian Poessinger
powerctl: T3066: Calculate minutes over 60
2020-11-13Merge pull request #603 from ernstjo/T3068Christian Poessinger
T3068: Automatic generation of IPv6 link local addresses for tunnel interfaces
2020-11-13Merge pull request #605 from kroy-the-rabbit/dhlengthChristian Poessinger
T3060: Fixing a backwards check on dh length
2020-11-13Merge pull request #606 from sever-sever/T3060Christian Poessinger
openvpn: T3060: Remote-host is a required param for client
2020-11-13openvpn: T3060: Remote-host is a required param for clientsever-sever
2020-11-13T3060: Fixing a backwares check on dh lengthkroy
2020-11-13Merge branch 'T1316_october' of https://github.com/sever-sever/vyos-1x into ↵Christian Poessinger
t1616-isis * 'T1316_october' of https://github.com/sever-sever/vyos-1x: isis: T1316: October steps
2020-11-13openvpn: T3060: fix CLI to real config mapping for protocol nodeChristian Poessinger
2020-11-13openvpn: T3051: fix smoketestChristian Poessinger
After commit 943a4a50 ("openvpn: T3051: fix creation of ifconfig-pool for client communication") the smoketests had nod been adjusted correctly. This has been fixed.
2020-11-13vyos.template: provide general is_ip(v4|v6) helpersChristian Poessinger
We had two places were the is_ip, is_ipv4 and is_ipv6 helpers had been defined. All places now have been converged into vyos.template as they are used both in the Jinja2 templates and also in our scripts.
2020-11-13openvpn: T3051: fix creation of ifconfig-pool for client communicationChristian Poessinger
2020-11-13T3068: Automatic generation of IPv6 link local addresses for tunnel interfacesernstjo
Better implementation to assign link local addresses automatically because address only assigned to interfaces which supports IPv6 addresses.
2020-11-13T3068: Automatic generation of IPv6 link local addresses for tunnel interfacesernstjo
Tunnel interfaces hot having any IPv6 Link Local address because Linux Kernel does not assign address due to missing MAC. I have implemented a function to generate a linl local address and assign it to the interface. Link local address is required for OSPF and other protocols.
2020-11-13powerctl: T3066: Calculate minutes over 60DmitriyEshenko
2020-11-13wwan: T3065: add IPv6 support for wirelessmodem interfacesChristian Poessinger
2020-11-13Merge pull request #601 from jack9603301/T3042Daniil Baturin
bridge: T3042: Fix VLAN filter invalid work
2020-11-13bridge: T3042: Fix VLAN filter invalid workjack9603301
1. Due to the previous focus on the implementation of VLAN filter, it was not considered to include MTU settings, which will lead to MTU setting errors in some cases 2. In order to make VLAN aware of the work of the bridge, it is necessary to specify the allowed VLAN ID range for the bridge itself, and forget to join it before
2020-11-12udev: T3063: drop special WWAN rule for Sierra Wireless cardsChristian Poessinger
This is no longer required after commit for the VyOS Kernel configuration https://github.com/vyos/vyos-build/commit/3fa7fe6926a538a8b4f25
2020-11-12bridge: T3042: ease help string on allowed-vlan and native-vlanChristian Poessinger
2020-11-12ssh: T2635: drop superfluous importChristian Poessinger
Commit a1327d2b970 ("ssh: T2635: reuse common verify_vrf() function") already moved to the common verify logic but did not remove the no longer needed import statement.
2020-11-12Merge pull request #600 from sever-sever/T2174Christian Poessinger
bgp-new: T2174: Fix abbility to del global route-map param
2020-11-12l2tpv3: T3059: fix interface state which is permanently downernstjo
2020-11-12Merge pull request #594 from jack9603301/T3042John Estabrook
bridge: T3042: Support VLAN filter and VLAN sub-interface on the bridge
2020-11-12bgp-new: T2174: Fix abbility to del global route-map paramsever-sever
2020-11-11 mpls-conf: T915: Add MPLS misc parameters, add LDP misc parametersCheeze-It
This commit has to do with the addition of miscellaneous MPLS parameters, as well as miscellaneous LDP parameters. Per c-po, for miscellaneous options and whatnot that do not fit anywhere we will put them into a specific "parameters" node. I also did some global linux configuration changes here. We make changes to kernel options "net.mpls.ip_ttl_propagate" and "net.mpls.default_ttl" which should allow the behavior of VyOS to have the same as routers from the big vendors. I added two LDP options for cisco interoperation TLV and for a dual stack preference. Lastly, I went through and changes some of the help/description fields in the definitions page because I just felt they weren't uniform and the words seemed to not properly explain what they were doing. I also did some code clean up (or tried to...) with comments and whatnot.
2020-11-11wwan: T2529: fix validation logic for non existing devicesChristian Poessinger
A non existing device usb0b1.4p1.?? device was not detected, as find_device_file() returned None which can not be passed into os.path.exists(). Traceback (most recent call last): File "/usr/libexec/vyos/conf_mode/interfaces-wirelessmodem.py", line 126, in <module> verify(c) File "/usr/libexec/vyos/conf_mode/interfaces-wirelessmodem.py", line 60, in verify if dev_path is None or os.path.exists(find_device_file(dev_path)): File "/usr/lib/python3.7/genericpath.py", line 19, in exists os.stat(path) TypeError: stat: path should be string, bytes, os.PathLike or integer, not NoneType
2020-11-10bridge: T3042: Support VLAN filter and VLAN sub-interface on the bridgejack9603301
2020-11-09Merge pull request #597 from Cheeze-It/currentChristian Poessinger
mpls-conf: T915: Add targeted LDP neighbors with parameters
2020-11-08mpls-conf: T915: Add targeted LDP neighbors with parametersCheeze_It
The commit has to do with the addition of targeted LDP neighbors and parameters being added. FRR allows for this functionality and I just wanted to add it. We have basically 4 options that are added. Enabling targeted LDP functionality, the targeted neighbor, the hello interval of targeted sessions, and the hold time of targeted sessions. Both IPv4 and IPv6 has been coded in.
2020-11-07interfaces: dhcp-client: T2997: add option to not request DHCP router addressChristian Poessinger
Some might want to have an IP address handed out by a DHCP server but not want a default route to be installed. This can be done using the CLI command: "set interfaces ethernet eth2 dhcp-options no-default-route"
2020-11-07smoketest: tunnel: enable common MTU testcaseChristian Poessinger
2020-11-07l2tpv3: T2653: include common "ip" interface optionsChristian Poessinger
2020-11-07macsec: T2653: include common "ip" and "ipv6" interface optionsChristian Poessinger
2020-11-07geneve: T2653: include common "ip" and "ipv6" interface optionsChristian Poessinger
2020-11-07T2653: migrate "ip" and "ipv6" interface options to generic includesChristian Poessinger
This reduces duplicated #include statements as each interface type already contained the individual includes.
2020-11-07smoketest: tunnel: add individual tunnel verification logicChristian Poessinger
2020-11-06op-mode: T2731: fix "show interfaces" returns invalid state when link is downChristian Poessinger
There has been a miss-match of admin-down and oper-down status for the Python implementation of "show interfaces".
2020-11-06validator: ipv4-range: T3050: fix wrong exit code when no range was givenChristian Poessinger
2020-11-06system: T3048: use proper service name "tuned.service"Christian Poessinger
2020-11-06system: T3048: add dynamic performance tuning daemonChristian Poessinger
Add new CLI command "set system options performance <latency | throughput>"
2020-11-06openvpn: T3051: fix multiple pushed routes to preconfigured clientsChristian Poessinger
2020-11-05Merge pull request #596 from Cheeze-It/currentChristian Poessinger
mpls-conf: T915: Add session hold time adjustment for LDP neighbors
2020-11-04mpls-conf: T915: Add session hold time adjustment for static LDP neighborsCheeze_It
The commit has to do with the addition of session hold time parameter for LDP neighbors. This allows for being able to change said hold time on a static neighbor. The way that this works is to have it either delegated to a value (15-65535), or to just be default to whatever FRR stipulates or per the other session configuration values. I opted to remove the "-ipv4-" only because we know it's an IPv4 session that one has to create first. I figure it's redundant to add it there so I removed it.