Bonding interface name 320 bond[0-9]+$ Bonding interface must be named bondN bondN Bonding interface name #include ARP link monitoring parameters ARP link monitoring interval 0-4294967295 Specifies the ARP link monitoring frequency in milliseconds IP address used for ARP monitoring ipv4 Network Time Protocol (NTP) IPv4 address #include #include Ignore link state changes Disable this bridge interface Bonding transmit hash policy layer2 layer2+3 layer3+4 layer2 use MAC addresses to generate the hash (802.3ad, default) layer2+3 combine MAC address and IP address to make hash layer3+4 combine IP address and port to make hash (layer2\+3|layer3\+4|layer2) hash-policy must be layer2 layer2+3 or layer3+4 ARP cache entry timeout in seconds 1-86400 ARP cache entry timout in seconds (default 30) ARP cache entry timeout must be between 1 and 86400 seconds Enable proxy-arp on this interface Enable private VLAN proxy ARP on this interface Media Access Control (MAC) address h:h:h:h:h:h Hardware (MAC) address Bonding mode 802.3ad active-backup broadcast round-robin transmit-load-balance adaptive-load-balance xor-hash 802.3ad IEEE 802.3ad Dynamic link aggregation (Default) active-backup Fault tolerant: only one slave in the bond is active broadcast Fault tolerant: transmits everything on all slave interfaces round-robin Load balance: transmit packets in sequential order transmit-load-balance Load balance: adapts based on transmit load and speed adaptive-load-balance Load balance: adapts based on transmit and receive plus ARP xor-hash Distribute based on MAC address (802.3ad|active-backup|broadcast|round-robin|transmit-load-balance|adaptive-load-balance|xor-hash) mode must be 802.3ad, active-backup, broadcast, round-robin, transmit-load-balance, adaptive-load-balance, or xor Bridge member interfaces Member interface name Maximum Transmission Unit (MTU) 68-9000 Maximum Transmission Unit MTU must be between 68 and 9000 Primary device interface #include #include