Point-to-Point Protocol over Ethernet (PPPoE) 321 ^pppoe[0-9]+$ PPPoE interface must be named pppoeN pppoeN PPPoE dialer interface name Access concentrator name (only connect to this concentrator) [a-zA-Z0-9]+$ Access concentrator name must be composed of uppper and lower case letters or numbers only Authentication settings User name Password Automatic establishment of PPPOE connection when traffic is sent Default route insertion behaviour (default: auto) auto none force (auto|none|force) PPPoE default-route option must be 'auto', 'none', or 'force' auto Automatically install a default route none Do not install a default route force Replace existing default route #include #include #include Delay before disconnecting idle session (in seconds) n Idle timeout in seconds IPv6 address configuration modes Enable Stateless Address Autoconfiguration (SLAAC) Activate IPv6 support on this connection Physical Interface used for this PPPoE session IPv4 address of local end of the PPPoE link ipv4 Address of local end of the PPPoE link Maximum Transmission Unit (MTU) 68-1500 Maximum Transmission Unit (default 1492) MTU must be between 68 and 1500 Do not use DNS servers provided by the peer IPv4 address of remote end of the PPPoE link ipv4 Address of remote end of the PPPoE link Service name, only connect to access concentrators advertising this [a-zA-Z0-9]+$ Service name must be composed of uppper and lower case letters or numbers only