High availability settings 800 Virtual Router Redundancy Protocol settings VRRP group Network interface Advertise interval 1-255 Advertise interval in seconds (default: 1) VRRP authentication VRRP password text Password string (up to 8 characters) .{1,8} Password must not be longer than 8 characters Authentication type plaintext-password ah (plaintext-password|ah) Authentication type must be plaintext-password or ah Group description Disable VRRP group Health check script Health check failure count required for transition to fault (default: 3) Health check execution interval in seconds (default: 60) Health check script file VRRP hello source address (IPv4 or IPv6) <IPv4|IPv6> IPv4 or IPv6 hello source address Unicast VRRP peer address (IPv4 or IPv6) <IPv4|IPv6> IPv4 or IPv6 unicast peer address Disable master preemption Preempt delay (in seconds) Router priority 1-255 Router priority (default: 100) Use VRRP virtual MAC address as per RFC3768 VRRP transition scripts Script to run on VRRP state transition to master Script to run on VRRP state transition to backup Script to run on VRRP state transition to fault Script to run on VRRP state transition to stop Virtual address (IPv4 or IPv6, but they must not be mixed in one group) Virtual address must be a valid IPv4 or IPv6 address with prefix length (e.g. 192.0.2.3/24 or 2001:db8:ff::10/64) <IPv4|IPv6> IPv4 or IPv6 virtual address Virtual address (If you need additional IPv4 and IPv6 in same group) ipv4 IP address ipv6 IPv6 address Virtual address must be a valid IPv4 or IPv6 address with prefix length (e.g. 192.0.2.3/24 or 2001:db8:ff::10/64) Virtual router identifier 1-255 Virtual router identifier VRRP sync group Sync group member text VRRP group name high-availability vrrp group VRRP transition scripts Script to run on VRRP state transition to master Script to run on VRRP state transition to backup Script to run on VRRP state transition to fault Script to run on VRRP state transition to stop