diff options
| -rw-r--r-- | docs/operation/raid.rst | 6 |
1 files changed, 3 insertions, 3 deletions
diff --git a/docs/operation/raid.rst b/docs/operation/raid.rst index 49463a72..30407718 100644 --- a/docs/operation/raid.rst +++ b/docs/operation/raid.rst @@ -154,7 +154,7 @@ To replace a bad disk within a RAID 1 set, perform the following steps: 1 - Remove the failed disk from the RAID 1 set by issuing the following command: -.. opcmd:: delete raid RAID‐1‐device member disk‐partition +.. opcmd:: delete raid <RAID‐1‐device> member <disk‐partition> where RAID-1-device is the name of the RAID 1 device (for example, md0) and disk-partition is the name of the failed disk partition (for example, sdb2). @@ -166,7 +166,7 @@ hot-swappable, then you must shut down the system before removing the disk. 4 - Format the new disk for RAID 1 by issuing the following command: -.. opcmd:: format <disk‐device1> like <disk‐device2> +.. opcmd:: format disk <disk‐device1> like <disk‐device2> where disk-device1 is the replacement disk (for example, sdb) and disk-device2 is the existing healthy disk (for example, sda). @@ -191,7 +191,7 @@ mirror synchronization, check and display information. disk partition to a RAID 1 set initiates mirror synchronization, where all data on the existing member partition is copied to the new partition. -.. opcmd:: format <disk‐device1> like <disk‐device2> +.. opcmd:: format disk <disk‐device1> like <disk‐device2> This command is typically used to prepare a disk to be added to a preexisting RAID 1 set (of which disk-device2 is already a member). |