diff options
Diffstat (limited to 'docs/appendix/examples/tunnelbroker-ipv6.rst')
| -rw-r--r-- | docs/appendix/examples/tunnelbroker-ipv6.rst | 12 |
1 files changed, 6 insertions, 6 deletions
diff --git a/docs/appendix/examples/tunnelbroker-ipv6.rst b/docs/appendix/examples/tunnelbroker-ipv6.rst index e8fc9a8b..2977604d 100644 --- a/docs/appendix/examples/tunnelbroker-ipv6.rst +++ b/docs/appendix/examples/tunnelbroker-ipv6.rst @@ -17,7 +17,7 @@ Setting up the initial tunnel - Set up the initial IPv6 tunnel. Replace the field below from the fields on the `Tunnelbroker.net <https://www.tunnelbroker.net/>`_ tunnel information page. -.. code-block:: console +.. code-block:: none conf set interfaces tunnel tun0 address Client_IPv6_from_Tunnelbroker # This will be your VyOS install's public IPv6 address @@ -34,7 +34,7 @@ Setting up the initial tunnel - At this point you should be able to ping an IPv6 address. Try pinging Google: -.. code-block:: console +.. code-block:: none ping6 -c2 2001:4860:4860::8888 @@ -47,7 +47,7 @@ Setting up the initial tunnel - Assuming the pings are successful, you need to add some DNS servers. Some options: -.. code-block:: console +.. code-block:: none set system name-server 2001:4860:4860::8888 # Google set system name-server 2001:4860:4860::8844 # Google @@ -57,7 +57,7 @@ Setting up the initial tunnel - You should now be able to ping something by IPv6 DNS name: -.. code-block:: console +.. code-block:: none # ping6 -c2 one.one.one.one PING one.one.one.one(one.one.one.one) 56 data bytes @@ -87,7 +87,7 @@ Single LAN Setup Single LAN setup where eth1 is your LAN interface. Use the /64 (all the xxxx should be replaced with the information from your `Routed /64` tunnel): -.. code-block:: console +.. code-block:: none set interfaces ethernet eth1 address '2001:470:xxxx:xxxx::1/64' set interfaces ethernet eth1 ipv6 router-advert name-server '2001:4860:4860::8888' @@ -118,7 +118,7 @@ In the above examples, 1,2,ffff are all chosen by you. You can use 1-ffff (1-65 So, when your LAN is eth1, your DMZ is eth2, your cameras live on eth3, etc: -.. code-block:: console +.. code-block:: none set interfaces ethernet eth1 address '2001:470:xxxx:1::1/64' set interfaces ethernet eth1 ipv6 router-advert name-server '2001:4860:4860::8888' |