diff options
Diffstat (limited to 'docs/configuration/interfaces')
| -rw-r--r-- | docs/configuration/interfaces/wwan.rst | 237 | 
1 files changed, 233 insertions, 4 deletions
diff --git a/docs/configuration/interfaces/wwan.rst b/docs/configuration/interfaces/wwan.rst index e1728b56..faeb08ff 100644 --- a/docs/configuration/interfaces/wwan.rst +++ b/docs/configuration/interfaces/wwan.rst @@ -68,16 +68,225 @@ WirelessModem (WWAN) options  .. cfgcmd:: set interfaces wwan <interface> apn <apn> -   Every WWAN connection requires an :abbr:`APN (Access Point Name)` which is -   used by the client to dial into the ISPs network. This is a mandatory -   parameter. Contact your Service Provider for correct APN. +  Every WWAN connection requires an :abbr:`APN (Access Point Name)` which is +  used by the client to dial into the ISPs network. This is a mandatory +  parameter. Contact your Service Provider for correct APN.  *********  Operation  ********* -TBD +.. opcmd:: show interfaces wwan <interface> + +  Show detailed information on given `<interface>` + +  .. code-block:: + +    vyos@vyos:~$ show interfaces wwan wwan0 +    wwan0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UNKNOWN group default qlen 1000 +        link/ether 02:c2:f3:00:01:02 brd ff:ff:ff:ff:ff:ff +        inet 10.155.144.12/30 brd 10.155.144.15 scope global dynamic wwan0 +           valid_lft 7012sec preferred_lft 7012sec +        inet6 fe80::c2:f3ff:fe00:0102/64 scope link +           valid_lft forever preferred_lft forever + +        RX:  bytes  packets  errors  dropped  overrun       mcast +               640        2       0        0        0           0 +        TX:  bytes  packets  errors  dropped  carrier  collisions +              3229       16       0        0        0           0 + +.. opcmd:: show interfaces wwan <interface> summary + +  Show detailed information summary on given `<interface>` + +  .. code-block:: + +    vyos@vyos:~$ show interfaces wwan wwan0 summary +      -------------------------------- +      General  |            dbus path: /org/freedesktop/ModemManager1/Modem/0 +               |            device id: 79f4e9cc2e9fc8d4a3b8c8f6327c2e363170194d +      -------------------------------- +      Hardware |         manufacturer: Sierra Wireless, Incorporated +               |                model: MC7710 +               |             revision: SWI9200X_03.05.29.03ap r6485 CNSHZ-ED-XP0031 2014/12/02 17:53:15 +               |         h/w revision: 1.0 +               |            supported: gsm-umts, lte +               |              current: gsm-umts, lte +               |         equipment id: 358xxxxxxxxxxxx +      -------------------------------- +      System   |               device: /sys/devices/pci0000:00/0000:00:13.0/usb3/3-1/3-1.3 +               |              drivers: qcserial, qmi_wwan +               |               plugin: Generic +               |         primary port: cdc-wdm0 +               |                ports: ttyUSB0 (qcdm), ttyUSB2 (at), cdc-wdm0 (qmi), wwan0 (net) +      -------------------------------- +      Numbers  |                  own: 4917xxxxxxxx +      -------------------------------- +      Status   |                 lock: sim-pin2 +               |       unlock retries: sim-pin (3), sim-pin2 (3), sim-puk (10), sim-puk2 (10) +               |                state: connected +               |          power state: on +               |          access tech: lte +               |       signal quality: 63% (recent) +      -------------------------------- +      Modes    |            supported: allowed: 2g; preferred: none +               |                       allowed: 3g; preferred: none +               |                       allowed: 4g; preferred: none +               |                       allowed: 2g, 3g; preferred: 3g +               |                       allowed: 2g, 3g; preferred: 2g +               |                       allowed: 2g, 4g; preferred: 4g +               |                       allowed: 2g, 4g; preferred: 2g +               |                       allowed: 3g, 4g; preferred: 3g +               |                       allowed: 3g, 4g; preferred: 4g +               |                       allowed: 2g, 3g, 4g; preferred: 4g +               |                       allowed: 2g, 3g, 4g; preferred: 3g +               |                       allowed: 2g, 3g, 4g; preferred: 2g +               |              current: allowed: 2g, 3g, 4g; preferred: 2g +      -------------------------------- +      Bands    |            supported: egsm, dcs, pcs, utran-1, utran-8, eutran-1, eutran-3, +               |                       eutran-7, eutran-8, eutran-20 +               |              current: egsm, dcs, pcs, utran-1, utran-8, eutran-1, eutran-3, +               |                       eutran-7, eutran-8, eutran-20 +      -------------------------------- +      IP       |            supported: ipv4, ipv6, ipv4v6 +      -------------------------------- +      3GPP     |                 imei: 358xxxxxxxxxxxx +               |          operator id: 26201 +               |        operator name: Telekom.de +               |         registration: home +      -------------------------------- +      3GPP EPS | ue mode of operation: ps-1 +      -------------------------------- +      SIM      |            dbus path: /org/freedesktop/ModemManager1/SIM/0 +      -------------------------------- +      Bearer   |            dbus path: /org/freedesktop/ModemManager1/Bearer/0 + + +.. opcmd:: show interfaces wwan <interface> capabilities + +  Show WWAN module hardware capabilities. + +  .. code-block:: + +    vyos@vyos:~$ show interfaces wwan wwan0 capabilities +    Max TX channel rate: '50000000' +    Max RX channel rate: '100000000' +    Data Service: 'simultaneous-cs-ps' +    SIM: 'supported' +    Networks: 'gsm, umts, lte' +    Bands: 'gsm-dcs-1800, gsm-900-extended, gsm-900-primary, gsm-pcs-1900, wcdma-2100, wcdma-900' +    LTE bands: '1, 3, 7, 8, 20' + +.. opcmd:: show interfaces wwan <interface> firmware + +  Show WWAN module firmware. + +  .. code-block:: + +    vyos@vyos:~$ show interfaces wwan wwan0 firmware +    Model: MC7710 +    Boot version: SWI9200X_03.05.29.03bt r6485 CNSHZ-ED-XP0031 2014/12/02 17:33:08 +    AMSS version: SWI9200X_03.05.29.03ap r6485 CNSHZ-ED-XP0031 2014/12/02 17:53:15 +    SKU ID: unknown +    Package ID: unknown +    Carrier ID: 0 +    Config version: unknown + + +.. opcmd:: show interfaces wwan <interface> imei + +  Show WWAN module IMEI. + +  .. code-block:: + +    vyos@vyos:~$ show interfaces wwan wwan0 imei +    ESN: '0' +    IMEI: '358xxxxxxxxxxxx' +    MEID: 'unknown' + +.. opcmd:: show interfaces wwan <interface> imsi + +  Show WWAN module IMSI. + +  .. code-block:: + +    vyos@vyos:~$ show interfaces wwan wwan0 imsi +    IMSI: '262xxxxxxxxxxxx' + +.. opcmd:: show interfaces wwan <interface> model + +  Show WWAN module model. + +  .. code-block:: + +    vyos@vyos:~$ show interfaces wwan wwan0 model +    Model: 'MC7710' + +.. opcmd:: show interfaces wwan <interface> msisdn + +  Show WWAN module MSISDN. + +  .. code-block:: + +    vyos@vyos:~$ show interfaces wwan wwan0 msisdn +    MSISDN: '4917xxxxxxxx' + +.. opcmd:: show interfaces wwan <interface> revision + +  Show WWAN module hardware revision. + +  .. code-block:: + +    vyos@vyos:~$ show interfaces wwan wwan0 revision +    Revision: 'SWI9200X_03.05.29.03ap r6485 CNSHZ-ED-XP0031 2014/12/02 17:53:15' + +.. opcmd:: show interfaces wwan <interface> signal + +  Show WWAN module signal strength. + +  .. code-block:: + +    vyos@vyos:~$ show interfaces wwan wwan0 signal +    LTE: +    RSSI: '-74 dBm' +    RSRQ: '-7 dB' +    RSRP: '-100 dBm' +    SNR: '13.0 dB' +    Radio Interface:   'lte' +    Active Band Class: 'eutran-3' +    Active Channel:    '1300' + +.. opcmd:: show interfaces wwan <interface> sim + +  Show WWAN module SIM card information. + +  .. code-block:: + +    vyos@vyos:~$ show interfaces wwan wwan0 sim +    Provisioning applications: +    Primary GW:   slot '1', application '1' +    Primary 1X:   session doesn't exist +    Secondary GW: session doesn't exist +    Secondary 1X: session doesn't exist +    Slot [1]: +    Card state: 'present' +    UPIN state: 'not-initialized' +    UPIN retries: '0' +    UPUK retries: '0' +    Application [1]: +    Application type:  'usim (2)' +    Application state: 'ready' +    Application ID: +    A0:00:00:00:87:10:02:FF:49:94:20:89:03:10:00:00 +    Personalization state: 'ready' +    UPIN replaces PIN1: 'no' +    PIN1 state: 'disabled' +    PIN1 retries: '3' +    PUK1 retries: '10' +    PIN2 state: 'enabled-not-verified' +    PIN2 retries: '3' +    PUK2 retries: '10'  *******  Example @@ -105,3 +314,23 @@ The following hardware modules have been tested successfully in an  * Sierra Wireless AirPrime MC7710 miniPCIe card (LTE)  * Huawei ME909u-521 miniPCIe card (LTE)  * Huawei ME909s-120 miniPCIe card (LTE) + +*************** +Firmware Update +*************** + +All available WWAN cards have a build in, reprogrammable firmware. Most of the +vendors provide a regular update to the firmware used in the baseband chip. + +As VyOS makes use of the QMI interface to connect to the WWAN modem cards, also +the firmware can be reprogrammed. + +To update the firmware, VyOS also ships the `qmi-firmware-update` binary. To +upgrade the firmware of an e.g. Sierra Wireless MC7710 module to the firmware +provided in the file ``9999999_9999999_9200_03.05.14.00_00_generic_000.000_001_SPKG_MC.cwe`` +use the following command: + +.. code-block:: bash + +  $ sudo qmi-firmware-update --update -d 1199:68a2 \ +     9999999_9999999_9200_03.05.14.00_00_generic_000.000_001_SPKG_MC.cwe  | 
