.. _systemusers: Login ----- The default VyOS user account (`vyos`), as well as newly created user accounts, have all capabilities to configure the system. All accounts have sudo capabilities and therefore can operate as root on the system. Setting the level to admin is optional, all accounts on the system will have admin privileges. Both local administered and remote administered RADIUS (Remote Authentication Dial-In User Service) accounts are supported. Local ^^^^^ Create user account `jsmith` and the password `mypassword`. .. code-block:: sh set system login user jsmith full-name "Johan Smith" set system login user jsmith authentication plaintext-password mypassword The command: .. code-block:: sh show system login will show the contents of :code:`system login` configuration node: .. code-block:: sh user jsmith { authentication { encrypted-password $6$0OQH[...]vViOFPBoFxIi.iqjqrvsQdQ./cfiiPT. plaintext-password "" } full-name "Johan Smith" level admin } SSH with Public Keys ******************** The following command will load the public key `dev.pub` for user `jsmith` .. code-block:: sh loadkey jsmith dev.pub .. note:: This requires uploading the `dev.pub` public key to the VyOS router first. As an alternative you can also load the SSH public key directly from a remote system: .. code-block:: sh loadkey jsmith scp://devuser@dev001.vyos.net/home/devuser/.ssh/dev.pub In addition SSH public keys can be fully added using the CLI. Each key can be given a unique identifier, `calypso` is used oin the example below to id an SSH key. .. code-block:: sh set system login user jsmith authentication public-keys callisto key 'AAAABo..Q==' set system login user jsmith authentication public-keys callisto type 'ssh-rsa' RADIUS ^^^^^^ VyOS supports using one or more RADIUS servers as backend for user authentication. The following command sets up two servers for RADIUS authentication, one with a discrete timeout of `5` seconds and a discrete port of `1812` and the other using a default timeout and port. .. code-block:: sh set system login radius server 192.168.1.2 secret 's3cr3t0815' set system login radius server 192.168.1.2 timeout '5' set system login radius server 192.168.1.2 port '1812' set system login radius server 192.168.1.3 secret 's3cr3t0816' This configuration results in: .. code-block:: sh show system login radius { server 192.168.1.2 { secret s3cr3t0815 timeout 5 port 1812 } server 192.168.1.3 { secret s3cr3t0816 } } .. note:: If you wan't to have admin users to authenticate via RADIUS it is essential to sent the ``Cisco-AV-Pair shell:priv-lvl=15`` attribute. Without the attribute you will only get regular, non privilegued, system users. Source Address ************** RADIUS servers could be hardened by only allowing certain IP addresses to connect. As of this the source address of each RADIUS query can be configured. If this is not set incoming connections to the RADIUS server will use the nearest interface address pointing towards the RADIUS server - making it error prone on e.g. OSPF networks when a link fails. .. code-block:: sh set system login radius source-address 192.168.1.254 Login Banner ^^^^^^^^^^^^ You are able to set post-login or pre-login messages with the following lines: .. code-block:: sh set system login banner pre-login "UNAUTHORIZED USE OF THIS SYSTEM IS PROHIBITED\n" set system login banner post-login "Welcome to VyOS" **\\n** create a newline.