blob: d5788c3582c1a66d044034960ea05e6d0a20684c (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
|
.. _l2tpv3-interface:
L2TPv3
------
L2TPv3 is a pseudowire protocol, you can read more about on `Wikipedia L2TPv3`_
or in :rfc:`3921`
L2TPv3 can transport any traffic including ethernet frames. L2TPv2 is limited
to PPP.
Over IP
^^^^^^^
.. code-block:: sh
# show interfaces l2tpv3
l2tpv3 l2tpeth10 {
address 192.168.37.1/27
encapsulation ip
local-ip 192.0.2.1
peer-session-id 100
peer-tunnel-id 200
remote-ip 203.0.113.24
session-id 100
tunnel-id 200
}
Inverse configuration has to be applied to the remote side.
Over UDP
^^^^^^^^
UDP mode works better with NAT:
* Set local-ip to your local IP (LAN).
* Add a forwarding rule matching UDP port on your internet router.
.. code-block:: sh
# show interfaces l2tpv3
l2tpv3 l2tpeth10 {
address 192.168.37.1/27
destination-port 9001
encapsulation udp
local-ip 192.0.2.1
peer-session-id 100
peer-tunnel-id 200
remote-ip 203.0.113.24
session-id 100
source-port 9000
tunnel-id 200
}
To create more than one tunnel, use distinct UDP ports.
Over IPSec, L2 VPN (bridge)
^^^^^^^^^^^^^^^^^^^^^^^^^^^
This is the LAN extension use case. The eth0 port of the distant VPN peers
will be directly connected like if there was a switch between them.
IPSec:
.. code-block:: sh
set vpn ipsec ipsec-interfaces <VPN-interface>
set vpn ipsec esp-group test-ESP-1 compression 'disable'
set vpn ipsec esp-group test-ESP-1 lifetime '3600'
set vpn ipsec esp-group test-ESP-1 mode 'transport'
set vpn ipsec esp-group test-ESP-1 pfs 'enable'
set vpn ipsec esp-group test-ESP-1 proposal 1 encryption 'aes128'
set vpn ipsec esp-group test-ESP-1 proposal 1 hash 'sha1'
set vpn ipsec ike-group test-IKE-1 ikev2-reauth 'no'
set vpn ipsec ike-group test-IKE-1 key-exchange 'ikev1'
set vpn ipsec ike-group test-IKE-1 lifetime '3600'
set vpn ipsec ike-group test-IKE-1 proposal 1 dh-group '5'
set vpn ipsec ike-group test-IKE-1 proposal 1 encryption 'aes128'
set vpn ipsec ike-group test-IKE-1 proposal 1 hash 'sha1'
set vpn ipsec site-to-site peer <peer-ip> authentication mode 'pre-shared-secret'
set vpn ipsec site-to-site peer <peer-ip> authentication pre-shared-secret <pre-shared-key>
set vpn ipsec site-to-site peer <peer-ip> connection-type 'initiate'
set vpn ipsec site-to-site peer <peer-ip> ike-group 'test-IKE-1'
set vpn ipsec site-to-site peer <peer-ip> ikev2-reauth 'inherit'
set vpn ipsec site-to-site peer <peer-ip> local-address <local-ip>
set vpn ipsec site-to-site peer <peer-ip> tunnel 1 allow-nat-networks 'disable'
set vpn ipsec site-to-site peer <peer-ip> tunnel 1 allow-public-networks 'disable'
set vpn ipsec site-to-site peer <peer-ip> tunnel 1 esp-group 'test-ESP-1'
set vpn ipsec site-to-site peer <peer-ip> tunnel 1 protocol 'l2tp'
Bridge:
.. code-block:: sh
set interfaces bridge br0 description 'L2 VPN Bridge'
# remote side in this example:
# set interfaces bridge br0 address '172.16.30.18/30'
set interfaces bridge br0 address '172.16.30.17/30'
set interfaces bridge br0 member interface eth0
set interfaces ethernet eth0 description 'L2 VPN Physical port'
L2TPv3:
.. code-block:: sh
set interfaces bridge br0 member interface 'l2tpeth0'
set interfaces l2tpv3 l2tpeth0 description 'L2 VPN Tunnel'
set interfaces l2tpv3 l2tpeth0 destination-port '5000'
set interfaces l2tpv3 l2tpeth0 encapsulation 'ip'
set interfaces l2tpv3 l2tpeth0 local-ip <local-ip>
set interfaces l2tpv3 l2tpeth0 mtu '1500'
set interfaces l2tpv3 l2tpeth0 peer-session-id '110'
set interfaces l2tpv3 l2tpeth0 peer-tunnel-id '10'
set interfaces l2tpv3 l2tpeth0 remote-ip <peer-ip>
set interfaces l2tpv3 l2tpeth0 session-id '110'
set interfaces l2tpv3 l2tpeth0 source-port '5000'
set interfaces l2tpv3 l2tpeth0 tunnel-id '10'
.. _`Wikipedia L2TPv3`: http://en.wikipedia.org/wiki/L2TPv3
|
