Merge remote-tracking branch 'origin/current' into feat/docs-llms-txt-current

# Conflicts:
#	docs/conf.py

1 files changed, 74 insertions, 0 deletions

diff --git a/docs/vpp/configuration/dataplane/ipsec.md b/docs/vpp/configuration/dataplane/ipsec.md
new file mode 100644
index 00000000..0a66221f
--- /dev/null
+++ b/docs/vpp/configuration/dataplane/ipsec.md
@@ -0,0 +1,74 @@
+---
+lastproofread: '2026-02-23'
+---
+
+(vpp-config-dataplane-ipsec)=
+
+```{include} /_include/need_improvement.txt
+```
+
+
+# VPP IPsec Configuration
+
+VPP supports IPsec (Internet Protocol Security) offloading from the
+kernel, which speeds up cryptographic operations by leveraging VPP's
+high-performance packet processing capabilities.
+
+IPsec does not require any specific configuration on VPP side. If both
+sources and destinations of the IPsec traffic are reachable via VPP
+interfaces, VPP will automatically offload the IPsec processing from
+the kernel. IPsec tunnels are configured in the VPN configuration
+section, see {ref}`ipsec_general`.
+
+## IPsec Configuration Parameters
+
+### enable IPsec acceleration
+
+When VPP is used for offloading IPsec, it creates a virtual interface to
+connect to peers. The interface type is always 'ipsec', which is used for
+IPsec tunnels.
+
+```{cfgcmd} set vpp settings ipsec-acceleration
+```
+
+Enabling this option allows VPP to handle IPsec traffic more efficiently by
+offloading processing from the kernel.
+
+### netlink
+
+VPP uses netlink to receive IPsec event messages from the kernel. Proper
+settings of the following parameters are crucial for ensuring that VPP can
+process all such messages:
+
+```{cfgcmd} set vpp settings lcp netlink batch-delay-ms \<milliseconds\>
+```
+
+This parameter specifies the delay in milliseconds between processing
+batch netlink messages.
+
+```{cfgcmd} set vpp settings lcp netlink batch-size \<number\>
+```
+
+This parameter specifies the maximum number of netlink messages to
+process in a single batch.
+
+```{cfgcmd} set vpp settings lcp netlink rx-buffer-size \<number\>
+```
+
+This parameter specifies the size of the receive buffer for netlink
+socket. If you expect to offload many IPsec tunnels or get frequent and
+intensive rekeying, you may need to increase this value.
+
+:::{note}
+IPsec uses the same netlink parameters as LCP, so tuning them
+affects both LCP and IPsec processing.
+:::
+
+## Potential Issues and Troubleshooting
+
+Improper IPsec configuration can lead to various issues, including:
+
+- Failure to offload IPsec tunnels to VPP
+- Lost IPsec event messages due to insufficient netlink buffer size or
+  batch settings
+- IPsec states or SAs are not synchronized between kernel and VPP